Help ID a pie-shaped leftover part from a GSM iPhone 4 repair?

Hi. The triangular washer is a black spacer that is under the Phillips screw near the vibrator. Here's a picture of the spacer. As for the tiny foam block, are you referring to the outer plastic ring located on top of the rear camera's flash assembly?

해당 답변은 도움이 되었습니까?

예 아니요

점수 2

댓글 7개:

Well I think i found the piece of foam you're talking about. If you take a look at the picture of the speaker assembly, more specifically on the lower left corner, you'll notice this rectangular foam block. It looks like a brick. Is that it?

Walter Galan 의 2012년 7월 24일

yes walter this is the block. any idea about the pie slice metalic washer/spacer/contact?

MarkMatsuda 의 2012년 7월 24일

Well I'm glad we identified at least one of the components. Unfortunately I don't recall any triangular metallic spacer in the iPhone 4 GSM. Can you take a picture of the spacer?

Walter Galan 의 2012년 7월 24일

yes, but how do i post the photo to you. it seems to be the same size as the black piece in the Verizon model. All the photos and videos I am able to find show nothing under the 1.9 mm screw at teh bottom of the mother board under the ribbon connector bottom left. triangular with a hole slightly offset from center

MarkMatsuda 의 2012년 7월 24일

added a photo, it must fit under the screw as a contact plate between the screw head and the 1/2 circle brass contact point on the MB.

MarkMatsuda 의 2012년 7월 24일

댓글 2개 더보기

댓글 달기

Well I think i found the piece of foam you're talking about. If you take a look at the picture of the speaker assembly, more specifically on the lower left corner, you'll notice this rectangular foam block. It looks like a brick. Is that it? — Walter Galan
yes walter this is the block. any idea about the pie slice metalic washer/spacer/contact? — MarkMatsuda
Well I'm glad we identified at least one of the components. Unfortunately I don't recall any triangular metallic spacer in the iPhone 4 GSM. Can you take a picture of the spacer? — Walter Galan
yes, but how do i post the photo to you. it seems to be the same size as the black piece in the Verizon model. All the photos and videos I am able to find show nothing under the 1.9 mm screw at teh bottom of the mother board under the ribbon connector bottom left. triangular with a hole slightly offset from center — MarkMatsuda
added a photo, it must fit under the screw as a contact plate between the screw head and the 1/2 circle brass contact point on the MB. — MarkMatsuda

martin @martin19312 평판: 3k 16 12 · Answer 1 · 2011-08-17T22:33:44-07:00

martin @martin19312

평판: 3k

16

12

게시일: 2011년 8월 17일

옵션

My advice, if your iPhone still works then who cares! There are small parts like this throughout the phone that don't actually do anything and are just failsafe's if something does stop working. 99% of the time they are never needed :)

해당 답변은 도움이 되었습니까?

예 아니요

점수 0

댓글 달기

Warwick @warwick91082 평판: 1 · Answer 2 · 2012-07-15T21:16:44-07:00

Warwick @warwick91082

평판: 1

게시일: 2012년 7월 15일

옵션

I too have been unable to find where this part actually comes from.

My disassembly of the iphone 4 was all going well until i had to turn the frame over to seperate the screen from the body - that's when the piece fell out. I didnt even notice it in the phone before it fell.

Has anyone worked out where and what this is used for?

해당 답변은 도움이 되었습니까?

예 아니요

점수 0

댓글 달기

MarkMatsuda @markmatsuda 평판: 13 2 · Answer 3 · 2012-07-25T13:24:41-07:00

MarkMatsuda @markmatsuda

평판: 13

2

게시일: 2012년 7월 25일

옵션

I think this part is located under the 1.9 mm screw holding the bottom of the Mother board down. To the left side (from back)just above the speaker assembly. I am not certain but I believe its to aid contact of the screw to the Motherboard. the pointed side goes toward the outside frame and the the narrowest side to the bottom of the phone. The screw makes contact without it, so it will still work.

해당 답변은 도움이 되었습니까?

예 아니요

점수 0

댓글 달기

DarrenG @darreng55388 평판: 1 1 · Answer 4 · 2013-01-29T06:05:06-07:00

DarrenG @darreng55388

평판: 1

1

게시일: 2013년 1월 29일

옵션

I've just found the exact same washer during re-assembly of a GSM iPhone 4. I've done dozens of these and never come across this washer before. It's not the plastic washer used near the vibrator on a 4S, this is pie shaped metal.

It was stuck to the adhesive where the battery sits but musty have become dislodged from someplace, but where??

해당 답변은 도움이 되었습니까?

예 아니요

점수 0

댓글 달기

iPhone 4

Help ID a pie-shaped leftover part from a GSM iPhone 4 repair?

답변 5개

귀하의 답변을 추가하세요