주요 콘텐츠로 건너뛰기

First generation Apple iPad with Wi-Fi, available with 16, 32, or 64 GB. Model Number A1219. Repairs are straightforward and do not require heat.

142 질문 전체 보기

Why can't I get the metal spudger between frontpanel and the rear?

Hi,

I need to replace the front panel of my Ipad. My wife dropped the IPAD and the glass cover is completely shattered, but the IPAD is still operational.

I got all the necessary specialised tools and components, downloaded your repair guide and watched the video for this specific repair job.

I can't get the metal spudger (sold to me as the original IPAD opening tool) between frontpanel and the rear casing without damaging the rear casing.

Obviously I must be doing something wrong.

Please advise.

답변되었습니다! View the answer 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 0
의견 추가하세요

3개의 답변

선택된 해법

First, you should have at minimum two spudgers, but three to four is optimal. Make sure to start on the right side to get the tabs out. If using a wide spudger the damage to the housing will be minimal. I am able to get into an iPad without leaving a trace - so it is possible. Plan ahead and purchase ten spare clips as those break easily and are cheap. Also purchase spare pads so the replacement screen doesn't sit lower than the housing.

해당 답변은 도움이 되었습니까?

점수 0
의견 추가하세요

In fact, I think there's no way to open the iPad without breaking something.

I've damaged a little the inner plastic frame of the display and many plastic flaps (used to keep the display inside the case) broke off.

해당 답변은 도움이 되었습니까?

점수 0
의견 추가하세요

Hi ,

I also had some problems opening the Ipad, but in the end it worked. I had to replace the flaps. I just a plastic tool :)

Did you replace the screen with succes? because I didn't.

해당 답변은 도움이 되었습니까?

점수 0
의견 추가하세요

귀하의 답변을 추가하십시오

toine 가/이 대단히 고마워 할 것입니다.
조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 0

전체 시간: 1,036