주요 콘텐츠로 건너뛰기

2016년 9월 16일 출시. Model A1661, A1784, 또는 A1785. 32, 128 또는 256 GB 환경 설정 / 로즈 골드, 금색, 은색, 검정색, 칠흑색 및 (Product)빨간색으로 제공됩니다.

1364 질문 전체 보기

iPhone stuck on boot loop after lighting port replacement

I just replaced the charging port and tapic engine and now my phone is stuck in a boot loop. I went back and disconnected the front camera, home button, and doubled checked all connections. The only thing I noticed is that I did lose some screws during the process of checking things due to my children messing around and dropped the loose parts onto the carpet. I have ordered a screw kit which I’m hoping the issue is just the missing screws.

이 질문에 답하기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 0
댓글 달기

답변 3개

disconnect all flex cables except the dockconnector and battery to the logic board and boot your iphone, if it boots up then you can connect the flex cable one by one to look which causes the fault.

해당 답변은 도움이 되었습니까?

점수 0

댓글 4개:

I will give that a try in the morning, post update

disconnected charge board and phone boots up, that leads me to think that board is bad?

I think the board is not bad but the components you connect to the board one of them causes this boot loop.

Would a wrong sized tapic engine be a reason? They sent one for a 7 but needed a 7 plus and it's on back order which I'm waiting for them to get in stock

댓글 달기

did you get eny error code?

해당 답변은 도움이 되었습니까?

점수 0

댓글 1개:

No errors, unable to even get in to recovery mode when plugged into computer. The only thing I can think of is they sent a tapic engine for a 7 which is to small which is not connected.

댓글 달기

You may try hard reset it to see whether it works. This may be the simplest way to fix the issue. If it is helpful, you can also try restore your iPhone to factory settings. It’s an effective methods to solve many cases. Recover data from iPhone in advance before doing it.

해당 답변은 도움이 되었습니까?

점수 0
댓글 달기

귀하의 답변을 추가하세요

Daniel Van houten 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 1

30일 전: 3

전체 시간: 414