주요 콘텐츠로 건너뛰기

2014년 9월 19일에 출시된 이 5.5” 스크린 iPhone은 iPhone 6의 큰 버전입니다.

1525 질문 전체 보기

touch disease,, -5.7v problem

hi

i have iphone 6 plus with touch problem first i make jumper M1 pin on u2402 because this pin missing then test with diode value and resistant is normal but touch still disease and i measurement PN5V7_SAGE_AVDDN and this voltage only 5.3v im allready change chestnut (u1501) but the problem same -5v7 still low voltage

답변되었습니다! 답변 보기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

점수 0
댓글 달기

답변 1개

선택된 답변

Have you tried a known good screen?  What is the phones history?

You should not have touched chestnut. Now you have added variables to your repair. I have measured different voltages on that line and yours is acceptable.

You need to diode the connector and find what line is missing. If all the pins measure right I would try another meson than cumulus.

해당 답변은 도움이 되었습니까?

점수 1

댓글 1개:

phone was dropped from a few feet before

i was change lcd and problem still same

and diode value on connector was normal,, and change cumulus and meson (i get from normal board iphone) problem still same

댓글 달기

귀하의 답변을 추가하세요

Ronald E 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 1

전체 시간: 73