기기를 수리하세요 커뮤니티 상점

2018년 7월 출시, 15" MacBook Pro, 모델 A1989, True Tone 기술 15.4 inch LED-백라이트 화면, TouchID, 및 최대 Core i9 프로세서 여섯 개.

203 질문 전체 보기

옵션

No backlight or image

So i got this Macbook from my brother. Macbook Pro A1990 15 Inch. I got neither backlight or image on the screen.

No history of liquid spills or anything. It's fully functional on external monitor - and the webcam works.. But i doesn't seem like the internal display is even detected.

I've tried using a known working LCD panel and still no image. I guess it must be a logicboard/cable thing.

When i try booting into recovery-mode, i sometimes get working backlight on the LCD. But nothing else.

Also tried with a fresh installation of OSX. Still noting. It's a bit weird i think.

I see no indications of shorts or anything after visual inspection with a microscope.

I also get the correct voltages on pins 43/44 and 45/46 in the J8500 display connector.

Any ideas? Thank you

이 질문에 답하기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

예 아니요
점수 1
댓글 달기

답변 1개

필터:
가장 유용함 가장 최근 가장 오래된
가장 유용한 답변

옵션

I would inspect the logic board and the T-CON board connectors and the short eDP cable. I’m suspecting corrosion or bent contact.

If you don’t see anything check the Hall sensor units on the back side of the logic board. On the left & right sides you’ll find two elevated segments which press the sensors to the back side of the case, one or both may be bad.

해당 답변은 도움이 되었습니까?

예 아니요
점수 1

댓글 2개:

Thank you for answering @danj !

I just tested the board again, and i actually get 0V on Pin 43 (PPVOUT_S0_LCDBKLT). With and without the LCD connected.

I just got a new eDP cable and it didn't fix the issue unfortunately. I see no signs of corrosion.

I've used the display panel on a friends MacBook, and the panel was working fine. For that reason, I don't think the T-CON board is the problem. Do you think a defect Hall sensor could lead to the display not being recognized at all?

I'm guessing that somewhere on the logic board, the PPVOUT_S0_LCDBKLT voltage is not being created correctly. I just can't find the problem.

의

@Asmus Johansen - it could be the Buck converter logic which creates the backlight power or the Hall sensor logic both are one the main logic board. At this point you’ll need to just trace out the logic to discover what has failed. Do you have access to the full schematics and boardviews? You’ll need them.

의

댓글 달기

귀하의 답변을 추가하세요

Asmus Johansen 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 5

30일 전: 15

전체 시간: 285