기기를 수리하세요 커뮤니티 상점

Model No. A1367 / 8, 16, 32, or 64 GB capacity

914 질문 전체 보기

옵션

Questions about iPod Touch 4 disassembly

Hi! I have fixed iPhone 4 and am very comfortable working with them, but recently I have tried fixing damaged iPod touches, specifically ones with damaged screens.

These forth gen iPods have very annoying soldered flex cables for the volume and power.

Does anyone have any tips for me to avoid ripping the speaker out when removing the shield with a lot of screws? And avoid ripping that flex cable when installing the digitizer ribbon?

I have used patience and care, but they always seem to rip and become even more headaches for me!

Any tips would be appreciated thanks ;)

답변되었습니다! 답변 보기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

예 아니요
점수 -1
댓글 달기

답변 2개

필터:
가장 유용함 가장 최근 가장 오래된
선택된 답변

옵션

Hi

I Have done this a few times at it is a huge pain. I have broken a flex cable before. TO do this I usually put the casing of the ipod in a small vise and gently lift the circuit board as far as it will go without damaging the cable, use a small piece of plastic, usually the rear end of a small ipod opening tool to hold in this position. Then I use small tweezers to line up the cable. That is just how I do it their are probably better ways

해당 답변은 도움이 되었습니까?

예 아니요
점수 0

댓글 1개:

I put my fingers on the speaker side to hold it down.. Gives enough room leverage to lift the top side/right corner and do the fitting.

의

댓글 달기

옵션

To keep the volume cable from ripping try holding down the motherboard BEFORE you pry the metal plate off.

To keep the speaker from ripping off try heating the plate in that area before prying the plate from speaker. I metal spudger is the best tool for this.

If your not comfortable with either save your self the trouble and get a pro to do it for you.

해당 답변은 도움이 되었습니까?

예 아니요
점수 0
댓글 달기

귀하의 답변을 추가하세요

D D 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 451