기기를 수리하세요 커뮤니티 상점

4세대 iPhone의 CDMA 버전. 수리는 간단하지만 앞면 유리와 LCD를 하나의 유닛으로 교체해야 합니다. 16 또는 32GB / Model A1349 / CDMA 호환성.

295 질문 전체 보기

옵션

CDMA iPhone 4 bad reception; not antenna/motherboard

I have taken my Verizon iPhone 4 apart several times, but after my last conversion I have had bad service. I replaced the antenna/speaker module with no luck. Naturally, I figured that the problem lies with the motherboard, so I placed a fully working motherboard into the phone, but still no success. Also If I place the original motherboard into another phone it works fine. Is there something wrong with the frame of my phone that is making it have bad reception?

이 질문에 답하기 저도 같은 문제를 겪고 있습니다

좋은 질문 입니까?

예 아니요
점수 -1
댓글 1개

Did anyone figure out this problem? Just ran into it myself with a formally working iphone 4 cdma...

의

댓글 달기

답변 2개

필터:
가장 유용함 가장 최근 가장 오래된
가장 유용한 답변

옵션

You might want to clean all of the contacts with isopropyl to get any oils off of them. I replaced an iPhone 4's antenna and t had the same issue that you are describing here. Turns out that just a little bit of oil from your fingers can dramatically decrease and even cut off the signal. To prevent this, I always use latex gloves while working on electronics. You skald just take a small drop of isopropyl or another light degreaser and gently scrub each of the contacts with a soft brush. It fixed my problem. You might also have to clean the contacts on the logic board.

hope this Helps

해당 답변은 도움이 되었습니까?

예 아니요
점수 2

댓글 2개:

what could i use the alcohol to clean? from experimenting with mix and matching parts, the only thing that is consistent each time with the phone is the metal frame, the screen, the camera and button connectors, the dock connector and that small connector at the top of the phone that you put the shield over. I'm convinced that it isnt the motherboard or antenna because if i stick both of those into another phone they work fine together.

의

Could someone point out to me where the actual "contacts" are? I've had bad reception on WiFi and Bluetooth since someone repaired my phone but I can't figure out where I'm supposed to clean.

의

댓글 달기

옵션

Hello,

I totally agree with Owen. You should clean all the connections with Isopropyl at least 91% to get any oils off of them. Also I would examine the connectors under a microscope to make sure none of the connectors are damage, you can't see micro fracture with out a microscope.

Pressing to hard and taking your phone apart several times can damage these over time. If you have damaged them a little bit of micro soldering may be need to fully restore the connection.

Hope this helps!

해당 답변은 도움이 되었습니까?

예 아니요
점수 0
댓글 달기

귀하의 답변을 추가하세요

Rindikulous 님은 대단히 고마워 할 것입니다.
조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 2,562