소개

When a car is driven, tires tend to wear unevenly. To extend the life of tires, it is important to rotate the tires every 30,000 miles. This guide will show you how to remove and rotate tires.

도구

부품

부품은 필요하지 않습니다.

  1. Turn car off and remove keys from ignition.
    • Turn car off and remove keys from ignition.

    • Place car in park (automatic) or neutral (manual).

    • Engage parking brake.

    댓글 쓰기

  2. Use hydraulic jack on frame of car to raise car.
    • Use hydraulic jack on frame of car to raise car.

    • Place jack head underneath frame of car.

    • Only necessary to jack the car until the wheels are just off the ground.

    댓글 쓰기

    • Place jack stand on frame of car and remove jack.

    • Do no work under car supported only by hydraulic jack, serious injury or death may occur.

    댓글 쓰기

    • Turn car off and remove keys from ignition.

    • Place car in park (automatic) or neutral (manual).

    • Engage parking brake.

    댓글 쓰기

  3. Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
    Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
    • Use hydraulic jack on frame of car to raise car.

    • Place jack head underneath frame couple (pictured).

    • Only necessary to jack the car until the wheels are just off the ground.

    댓글 쓰기

    • Place jack stand on frame of car and remove jack.

    • Do not work under car supported only by hydraulic jack, serious injury or death may result.

    댓글 쓰기

    • Pry off the all four hub caps by placing a small flathead screwdriver between hubcap and rim pulling the screwdriver away from tire.

    • Pull hubcaps away from tires.

    댓글 쓰기

    • Loosen each of the five lug nuts on all tires by turning them counter-clockwise with a 19mm wrench.

    댓글 쓰기

    • Remove tires by pulling directly away from car exposing brake rotors.

    댓글 쓰기

    • Swap tires according to diagram.

    댓글 쓰기

    • Place tires on axels.

    • Hand tighten the lug nuts with narrow end of nut towards car.

    • Finish tightening the lug nuts with 19mm Torque Wrench to a torque of 63 lb*ft.

    댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

Garrett Van Ruiten

회원 가입일: 2010년 10월 11일

51 평판

안내서 2개 작성하였습니다

Cal Poly, Team 3-28, Regan Fall 2010 Cal Poly, Team 3-28, Regan Fall 2010 회원

CPSU-REGAN-F10S3G28

4 회원들

안내서 9개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 7

전체 시간: 2,331