1992-1999 BMW 3 Series Driver Side Airbag Replacement (1992, 1993, 1994, 1995, 1996, 1997, 1998, 1999) - iFixit 수리 안내서

소개

Use this guide to replace the driver side airbag in your BMW E36. This procedure was done on a US 1997 M3 with the four spoke steering wheel.

필요한 것

1 단계 Driver Side Airbag

This step is not necessary, but it made it easier for me to get at the steering column trim mounting screw. Feel free to skip this if you'd like.
Remove the two screws securing the upper edge of the knee bolster.
Pull the upper edge down to give access to the underside of the steering wheel.

2 단계

Remove the lower steering column trim mounting screw.
Remove the lower steering column trim.

3 단계

Make sure that the battery has been disconnected for at least 30 minutes before continuing further to ensure that the airbag light does not come on.
Disconnect the orange SRS connector.

4 단계

Completely loosen the two T30 Torx screws behind the steering wheel while supporting the airbag unit from the front.
Make sure to support the airbag to prevent it from falling out.

5 단계

Lift the airbag unit up and away from the steering wheel.
Disconnect the orange harness connector from the rear of the airbag unit.
The airbag should now be free to be removed.

결론

To reassemble your device, follow these instructions in reverse order.

작성자

다른 기여자 1명과 함께

Geoff Wacker

회원 가입일: 09/30/13

89,934 평판

안내서 89개 작성하였습니다

배지 +41개 더

댓글 0개

조회 통계:

24 시간 전: 0

7일 전: 4

30일 전: 15

전체 시간: 550