기기를 수리하세요 커뮤니티에 동참하기 상점

1998-2002 Honda Accord Distributor Cap Replacement

소개

Use this guide to replace your 4-cylinder Honda Accord's distributor cap. This specific guide was created for a non-VTEC F23A5 engine, but other 4-cylinder Honda engines will be similar enough to follow the same basic steps

필요한 것

  1. 1998-2002 Honda Accord Distributor Cap Replacement, Distributor Cap: 1 단계, 이미지 1/3 1998-2002 Honda Accord Distributor Cap Replacement, Distributor Cap: 1 단계, 이미지 2/3 1998-2002 Honda Accord Distributor Cap Replacement, Distributor Cap: 1 단계, 이미지 3/3

    • Before disconnecting the spark plug wires, be sure to trace their orientation from the individual cylinders back to the distributor cap.

    • The cylinders are ordered from left to right when viewing the engine from the front of the car, with cylinder #1 being closest to the passenger side of the vehicle.

    • Mark the order of the spark plug wires on the new distributor cap with a silver sharpie marker -- it will make reinstallation much easier.

    편집

  2. 1998-2002 Honda Accord Distributor Cap Replacement: 2 단계, 이미지 1/1

    • Disconnect the four spark plug wires from the distributor cap by pulling their connectors straight away from the sockets on the distributor cap.

    • It may be helpful to slightly twist the wires as you pull them.

    편집

  4. 1998-2002 Honda Accord Distributor Cap Replacement: 3 단계, 이미지 1/2 1998-2002 Honda Accord Distributor Cap Replacement: 3 단계, 이미지 2/2

    • Use a 1/4" drive, 8 mm deep socket to remove the three hex bolts securing the distributor cap to the engine.

    • The position of the third bolt is not visible in the second picture.

    편집

  5. 1998-2002 Honda Accord Distributor Cap Replacement: 4 단계, 이미지 1/1

    • Pull the distributor cap away from the engine and set it aside.

    편집

  6. 1998-2002 Honda Accord Distributor Cap Replacement: 5 단계, 이미지 1/2 1998-2002 Honda Accord Distributor Cap Replacement: 5 단계, 이미지 2/2

    • Use a dental pick or a small screwdriver to gently remove the D-shaped o-ring around the distributor cap flange.

    • Install a new o-ring in the seal recess, making sure that it is sitting flush against the flange.

    편집
결론

To reassemble your device, follow these instructions in reverse order.

다른 12명이 해당 안내서를 완성하였습니다.

작성자

다른 기여자 3명과 함께

Miroslav Djuric

156,975 평판

안내서 144개 작성하였습니다

Badges: 54

배지 +51개 더

4 댓글

I need to do this procedure. Have never done this in years. Next time I will change my wires, plugs and now my distributor cap.

Thurman - 답글

Where can I find the part number?

lawendellr - 답글

what about 6 cylinder

ssingam75 - 답글

excellent, thanks for you aportation.

julio cesar - 답글

댓글 쓰기

조회 통계:

24 시간 전: 5

7일 전: 56

30일 전: 219

전체 시간: 67,063