소개

A simple and effective guide on replacing the headlights, taillights, and overhead light.

부품

부품은 필요하지 않습니다.

  1. Open your tailgate fully, exposing both sides where the tailgate sits.
    • Open your tailgate fully, exposing both sides where the tailgate sits.

    댓글 쓰기

  2. Unscrew the two phillips head screws located above and below the tailgate support.
    • Unscrew the two phillips head screws located above and below the tailgate support.

    댓글 쓰기

    • Once the screws have been removed, simply pull off the taillight. The red plug is the taillight. Twist it a quarter turn counter clockwise, and pop it out.

    댓글 쓰기

  3. Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
    Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
    • Remove the old bulb and replace it with your new one.

    • Side note: Make sure replacement bulb is save voltage/amperage rating.

    댓글 쓰기

    • Open the hood and take a look above your headlights.

    댓글 쓰기

    • Two metal pins holding each of the headlights in place will need to be removed (no tool necessary).

    • Turn the plastic headlight mount counter clockwise by one quarter of a turn.

    • Then lift the pins up to fully remove them.

    댓글 쓰기

    • Once the pins have been removed, GENTLY pull your headlight upwards, towards you. The bulbs should now be exposed. The bulb on the top is your headlight.

    댓글 쓰기

    • As you did with the taillight bulb, turn the piece that is holding the bulb in place a quarter turn counter clockwise, and the bulb will pop out. Now your new bulb will take it's place.

    댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

다른 5명이 해당 안내서를 완성하였습니다.

keith beaudoin

회원 가입일: 2013년 10월 11일

275 평판

안내서 1개 작성함

University of Maryland, Team 4-7, Vijaybhaskar Fall 2013 University of Maryland, Team 4-7, Vijaybhaskar Fall 2013 회원

UMD-VIJAYBHASKAR-F13S4G7

2 회원들

안내서 1개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 4

전체 시간: 258