소개

An air filter is used to keep internal parts of the vehicle clean. A dirty air filter may lead to dirty spark plugs. The air filter should be replaced every six months. This guide will walk you through the process of replacing your old, dirty air filter.

도구

도구는 필요하지 않습니다.

  1. Locate the two grey latches on each side of the hood near the headlights.
    • Locate the two grey latches on each side of the hood near the headlights.

    • Pull the latches away from the hood to release the latches.

    댓글 쓰기

  2. Reach underneath the hood and push up on the lever located in the front center of the hood.  You can now open the hood.
    • Reach underneath the hood and push up on the lever located in the front center of the hood. You can now open the hood.

    • Prop the hood open by inserting the hood support rod into the designated hole on the underside of the hood.

    댓글 쓰기

    • Locate the air filter box in front of the car battery. It will have a 4-inch diameter hose coming out of one side (towards the center of the vehicle) and an air release coming out of the other side. It should have four clamps keeping it sealed.

    댓글 쓰기

    • Locate the four clips keeping the air filter box sealed. Their locations are as follows:

      • Back Left Corner (near the outer edge of the hood) [picture 1]

      • Front Left Corner (near the outer edge of the hood) [picture 1]

      • Back Right Corner (underneath the four-inch diameter hose) [picture 2]

      • Bottom Right Corner (near the steering fluid container in the front) [picture 3]

    댓글 쓰기

    • To unlock the air filter box, grasp each clip and pull the clip away from the air filter box.

    댓글 쓰기

    • After you have removed the 4 clips, carefully pull and twist the cover off. You now have access to the air filter.

    댓글 쓰기

    • Remove the dirty air filter by pulling the air filter straight up. Place the new replacement filter in the empty slot.

    • Refer to any labels on the filter about usage.

    댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

다른 2명이 해당 안내서를 완성하였습니다.

Adam Donald

회원 가입일: 2012년 09월 26일

227 평판

안내서 4개 작성하였습니다

Cal Poly, Team 7-51, Forte Fall 2012 Cal Poly, Team 7-51, Forte Fall 2012 회원

CPSU-FORTE-F12S7G51

5 회원들

안내서 9개 작성하였습니다

I couldn't get the housing unit off. :(

David J - 답글

You forgot to add the step about removing the two bolts from the air intake assembly. You can't lift the housing unit off unless you remove the bolts.

lahacade - 답글

댓글 쓰기

조회 통계:

지난 24시간: 1

지난 7일: 13

지난 30일: 48

전체 시간: 8,134