2015 Jeep Patriot Tail/ Brake Light Replacement

소개

To ensure the safety of drivers, it is important to have functioning brake lights. If the brake lights on your 2015 Jeep Patriot aren't illuminating and need to be replaced, use this guide to replace the lightbulb.

The purpose of a tail/ brake light is to make your car visible during nighttime and heavy weather conditions and to communicate to the driver behind you that you are slowing down or stopping. A broken tail/ brake light is dangerous to yourself and the drivers around you. You could also get pulled over and receive a citation if your tail light is out.

Before beginning the repair, park in a safe location, turn the car off and put the emergency brake on.

필요한 것

1 단계 Jeep Patriot Tail/ Brake Light Replacement

2015 Jeep Patriot Tail/ Brake Light Replacement, Jeep Patriot Tail/ Brake Light Replacement: 1 단계, 이미지 1/2

2015 Jeep Patriot Tail/ Brake Light Replacement, Jeep Patriot Tail/ Brake Light Replacement: 1 단계, 이미지 2/2

Open the trunk and locate the fender clips.
These are located near the tail lights.

편집

2 단계

2015 Jeep Patriot Tail/ Brake Light Replacement: 2 단계, 이미지 3/3

Use the 3/16 inch flathead screwdriver to remove the top fender clip holding the tail light on.

편집

3 단계

Remove the lower fender clip.
This will release the tail light so be careful.

편집

4 단계

Remove the tail light to expose the light bulb.

편집

5 단계

Twist the light bulb to remove it from the holder.
Replace the old bulb with the new one. make sure to twist the new bulb to secure it.
Do not touch the new light bulb with your bare hands as the oil from your fingers will cause it to degrade faster and possibly shatter.