소개

If you need to replace the buttons, you can access them with this guide. You may need to change the buttons if they are worn down, cracked, jammed, or missing. For this guide, you will need a plastic opening tool, Phillips #0 screwdriver, TR6 Torx Security screwdriver, and ESD-safe blunt nose tweezers (optional).

This repair process is not too difficult, but be careful to not damage anything when you take off the top panel. Make sure the controller is not plugged into a power source.

필요한 것

1 단계 Buttons

8BitDo Ultimate Wired Buttons Replacement, Buttons: 1 단계, 이미지 3개 중 1개

8BitDo Ultimate Wired Buttons Replacement, Buttons: 1 단계, 이미지 3개 중 2개

8BitDo Ultimate Wired Buttons Replacement, Buttons: 1 단계, 이미지 3개 중 3개

Orient the controller such that the back of the controller is facing you.
Insert an opening tool into the small opening on the back of the grip, and gently pry the grip cover away until it pops free.

편집

2 단계

8BitDo Ultimate Wired Buttons Replacement: 2 단계, 이미지 3개 중 3개

Pry the other grip panel off using the same method.

편집

3 단계

8BitDo Ultimate Wired Buttons Replacement: 3 단계, 이미지 3개 중 3개

Use the TR6 Torx Security screwdriver to remove the top left 10.44 mm torx screw on the backside.
Use tweezers to help remove the screws (optional).

편집

4 단계

8BitDo Ultimate Wired Buttons Replacement: 4 단계, 이미지 3개 중 3개

Use the TR6 Torx Security screwdriver to remove the middle left 10.44 mm Torx screw on the backside.

편집

5 단계

8BitDo Ultimate Wired Buttons Replacement: 5 단계, 이미지 3개 중 3개

Use the TR6 Torx Security screwdriver to remove the bottom left 10.44 mm Torx screw on the backside.

편집

6 단계

8BitDo Ultimate Wired Buttons Replacement: 6 단계, 이미지 3개 중 3개

Use the TR6 Torx Security screwdriver to remove the top right 10.44 mm Torx screw on the backside.

편집

7 단계

8BitDo Ultimate Wired Buttons Replacement: 7 단계, 이미지 3개 중 3개

Use the TR6 Torx Security screwdriver to remove the middle right 10.44 mm Torx screw on the backside.

편집

8 단계

8BitDo Ultimate Wired Buttons Replacement: 8 단계, 이미지 3개 중 3개

Use the TR6 Torx Security screwdriver to unscrew the bottom right 10.44 mm Torx screw on the backside.

편집

9 단계

Orient the controller such that the back of the controller is facing you.
Insert an opening tool into the small opening between the front and back panels, and gently pry the back panel away to open the bottom clamps of the top panel of the controller.

편집

10 단계

Insert an opening tool into the small opening between the front and back panel (top view) and pry away to remove the top half.
A ribbon cable connects the front and back portions of the controller.

편집