메인 콘텐츠로 스킵하기

소개

This guide will demonstrate how to replace the fingerprint scanner of a Zenfone 3. This may be necessary if the scanner no longer activates or inaccurately reads fingerprints. For this guide, you will need the tweezers, Torx T2 screwdriver, a prying tool, and the Phillips #00 screwdriver.

  1. Using a pair of tweezers, pull put the SIM card tray and set it to the side. Using a pair of tweezers, pull put the SIM card tray and set it to the side.
    • Using a pair of tweezers, pull put the SIM card tray and set it to the side.

  2. Remove the two 2 mm screws using a Torx T2 screwdriver.
    • Remove the two 2 mm screws using a Torx T2 screwdriver.

  3. Insert a prying tool between the screen and the metal backing of the phone at the bottom to remove backing from phone. There will be a thin film connecting the two pieces. You do not need to remove this. Just fold the two pieces apart with the inside facing up.
    • Insert a prying tool between the screen and the metal backing of the phone at the bottom to remove backing from phone.

    • There will be a thin film connecting the two pieces. You do not need to remove this. Just fold the two pieces apart with the inside facing up.

  4. 맥북 배터리 수리 키트

    기본 가격은 $69.99

    Buy Now

    맥북 배터리 수리 키트

    기본 가격은 $69.99

    Buy Now
  5. Remove the two 3 mm screws, using the Phillips #00 screwdriver, on the silver band at the top of the battery and remove the band.
    • Remove the two 3 mm screws, using the Phillips #00 screwdriver, on the silver band at the top of the battery and remove the band.

  6. Peel back the silver tape.
    • Peel back the silver tape.

  7. Disconnect the battery connections.
    • Disconnect the battery connections.

  8. Pry and remove the battery.
    • Pry and remove the battery.

    • The underside of the battery is adhesive so make sure to pry the battery off gently.

  9. Unplug the wire connecting the two large pieces of the device.  Next, seperate the two halves of the phone.
    • Unplug the wire connecting the two large pieces of the device. Next, seperate the two halves of the phone.

  10. Using the plastic opening tool, pry the fingerprint scanner out. Using the plastic opening tool, pry the fingerprint scanner out. Using the plastic opening tool, pry the fingerprint scanner out.
    • Using the plastic opening tool, pry the fingerprint scanner out.

결론

To reassemble your device, follow these instructions in reverse order.

Henry Barrett

회원 가입일: 2018년 09월 10일

480 평판

안내서 4개 작성하였습니다

University of Alabama, Team S2-G7, Bedsole Fall 2018 University of Alabama, Team S2-G7, Bedsole Fall 2018 회원

UA-BEDSOLE-F18S2G7

4 회원들

안내서 5개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 4

지난 30일: 21

전체 시간: 176