소개
This guide is used to properly install the belt on the AT-LP60X (or similar models). Proper installation of the belt can resolve lack of spinning conditions.
필요한 것
-
-
Remove the slipmat from the platter.
-
Pull the platter off by lifting vertically from the two circular holes.
-
-
-
Locate the belt.
-
Flip the platter upside-down and place the belt around the inner ring of the platter.
-
-
-
-
Place the platter back on the center spindle.
-
Spin the platter such that the gold pulley of the motor is showing.
-
Stretch the belt from the platter around the gold pulley of the motor.
-
-
-
Place the slipmat back onto the platter, and press the STOP button.
-
Using your right hand, secure the tone arm in place.
-
[OPTIONAL] Use a twist tie and the built in hook.
-
While the tone arm is secured, use your left hand to slowly spin the platter 10 times clockwise.
-
-
-
Any twists while installing the belt will cause improper operation.
-
The belt should NOT be connected to this white post.
-
The belt should NOT be connected to the base of the turntable.
-
If this guide does not fix the issue of the platter not spinning, the following issues could be present:
- Faulty AC Adaptor - Can be purchased here.
- Faulty Diode (D01) - Requires soldering (repair guide can be provided upon request: service@atus.com). Part Number: 576-SMAJ13A
- Faulty Motor - Requires soldering (repair guide can be provided upon request: service@atus.com). Part Number: 704-F706-7303
To send your turntable in for service, please follow the necessary steps from our website.
Feel free to contact one of our technicians for further assistance at (330)686-2600 ext.5004
다른 2명이 해당 안내서를 완성하였습니다.
