소개

This guide will show you how to adjust the height of the handle bars and align the stem with the front wheel.

부품

부품은 필요하지 않습니다.

Remove the bolt cover with a flathead screwdriver.
  • Remove the bolt cover with a flathead screwdriver.

댓글 쓰기

Loosen the goose-neck (adjustable quill stem) with a 6 mm Allen wrench.
  • Loosen the goose-neck (adjustable quill stem) with a 6 mm Allen wrench.

  • After loosening the goose-neck (adjustable quill stem), it still may be stiff. Hold the wheel from turning and twist the handlebars from side to side.

  • If quill stem is still stuck then place 6 mm Allen wrench firmly into bolt and tap with a mallet.

  • Position the handlebars to your preferred height. Make sure not to pull cable and housing to tight. I could adversely effect shifting and braking performance.

  • Make sure you don't raise quill stem above minimum insert line.

댓글 쓰기

  • Align the direction of the goose-neck (adjustable quill stem) with the front tire.

  • Firmly tighten the goose-neck (adjustable quill stem) bolt using a 6 mm Allen wrench.

  • Pop the bolt cover back on.

  • If calling a bicycle repair shop, refer to it as a adjustable quill stem (technical term) instead of goose-neck as mechanic may not know what you are talking about.

댓글 쓰기

결승점

다른 한 분이 해당 안내서를 완성하였습니다.

aaron thielk

회원 가입일: 2010년 10월 10일

1,705 평판

안내서 5개 작성하였습니다

Cal Poly, Team 5-13, Maness Fall 2010 Cal Poly, Team 5-13, Maness Fall 2010 회원

CPSU-MANESS-F10S5G13

4 회원들

안내서 11개 작성하였습니다

Anyone know where/how to buy a replacement bolt cover?

Bennett Hart - 답글

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 9

지난 30일: 36

전체 시간: 7,709