주요 콘텐츠로 건너뛰기

소개

The alarm unit is located behind the glove box. Once the glovebox is out of the way, you can remove the black plastic alarm unit, open it and change the dip switch for a less sensitive setting.

부품

지정된 부품이 없습니다.

  1. Adjusting the alarm glass breakage microphone sensitivity: step 2, image 1 of 1
    • Once the glove box is out of the way, it's easy to spot the alarm unit. The green connector will be plugged into it. I had already unplugged it when I took this picture.

  2. Adjusting the alarm glass breakage microphone sensitivity: step 3, image 1 of 1
    • It may be stubborn to get out because it is stuck down with double stick foam pads.

  3. Adjusting the alarm glass breakage microphone sensitivity: step 4, image 1 of 1
    • Remove the 4 screws (may be under the foam strips). This is the bottom of the circuit board.

  4. Adjusting the alarm glass breakage microphone sensitivity: step 5, image 1 of 1
    • Turn the board over and locate the 2 position dip switch.

    • This dip switch adjusts the glass breakage microphone sensitivity

    • Sensitivity settings:

    • 1 off & 2 off = high

    • 1 on & 2 off = mid (factory setting)

    • 1 off & 2 on = low

    • 1 on & 2 on = super low

결론

To reassemble your device, follow these instructions in reverse order.

다른 3명이 해당 안내서를 완성하였습니다.

mpeeples

회원 가입일: 2010년 04월 04일

184 평판

안내서 1개 작성함

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 3

30일 전: 26

전체 시간: 2,204