Astak Mole Antenna Replacement - iFixit 수리 안내서

소개

If you getting a new antenna doesn't work, there might be a problem with the antenna connection inside the camera. This guide will show you how to replace input cable that attaches the antenna to the motherboard.

필요한 것

1 단계 Lower Case

Astak Mole Antenna Replacement, Lower Case: 1 단계, 이미지 1/1

Remove the four bottom tabs in order to access the bottom screws.

2 단계

Astak Mole Antenna Replacement: 2 단계, 이미지 1/1

Remove all four 14 mm Phillips #1 screws.

3 단계

Astak Mole Antenna Replacement: 3 단계, 이미지 1/1

Remove the SD card.

4 단계

Astak Mole Antenna Replacement: 4 단계, 이미지 1/1

Pry up the motherboard on the four points using a spudger.
The regular black nylon spudger should be used whenever possible, especially around sensitive internal components.

5 단계

Astak Mole Antenna Replacement: 5 단계, 이미지 1/1

Gently pull back the motherboard to expose many of the component's wired connections.

6 단계 Antenna

Astak Mole Antenna Replacement, Antenna: 6 단계, 이미지 1/2

Astak Mole Antenna Replacement, Antenna: 6 단계, 이미지 2/2

Unscrew the antenna in a counter-clockwise rotation.

7 단계

Astak Mole Antenna Replacement: 7 단계, 이미지 1/1

Take out the screw holding the antenna wire with the PH1 size Phillips head bit.
Screw length: 5.3mm

8 단계

Astak Mole Antenna Replacement: 8 단계, 이미지 1/1

Gently pry open the circuit board attached to the antenna wire using a metal spudger.
The regular black nylon spudger should be used whenever possible, especially around sensitive internal components.

9 단계

Astak Mole Antenna Replacement: 9 단계, 이미지 1/1

Remove the antenna female end from the motherboard.

결론

To reassemble your device, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

작성자

다른 기여자 5명과 함께

Meshari Alkhelaiwi

회원 가입일: 09/15/16

143 평판

안내서 1개 작성함

배지 +3개 더

팀

USF Tampa, Team 2-2, Blackwell Fall 2016 USF Tampa, Team 2-2, Blackwell Fall 2016 회원

USFT-BLACKWELL-F16S2G2

4 회원들

안내서 12개 작성하였습니다

댓글 0개

조회 통계:

24 시간 전: 1

7일 전: 5

30일 전: 14

전체 시간: 448