Flip the computer over so that it is upside down.
  • Flip the computer over so that it is upside down.

  • Slide both latches away from each other (towards the outside).

  • Push the battery out with your fingers.

  • The actual battery is not shown in the photograph.

댓글 쓰기

On the back panel unscrew highlighted screws and carefully put them to the side as not to lose them.
  • On the back panel unscrew highlighted screws and carefully put them to the side as not to lose them.

댓글 쓰기

  • Locate the RAM chip highlighted in Blue and the two metal tabs holding it in place highlighted in red.

댓글 쓰기

  • Carefully use your thumbs to push out the metal tabs and the RAM should spring up.

댓글 쓰기

  • After the ram has sprung up, carefully grab the edges with your fingers and gently pull straight out.

댓글 쓰기

  • After you have gotten either more RAM or replacement RAM line up the pins and slot (highlighted red) in the RAM card with the pin on the computer.

  • Carefully insert the new ram in at the same angle that you removed it at.

  • The other side of the RAM slot is a place for more RAM if you want to put more in. The spaces are highlighted in blue.

댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

Connor

회원 가입일: 2010년 06월 24일

36 평판

안내서 1개 작성함

Cal Poly, Team 2-9, Johann Summer 2010 Cal Poly, Team 2-9, Johann Summer 2010 회원

CPSU-JOHANN-R10S2G9

5 회원들

안내서 11개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 2

전체 시간: 3,120