부품

부품은 필요하지 않습니다.

  1. Locate the back side of the phone.
    • Locate the back side of the phone.

    • The battery is the large main compartment (red box).

    댓글 쓰기

  2. Use your finger to slide the latch (circled) upwards.
    • Use your finger to slide the latch (circled) upwards.

    • While holding the latch up, pull the battery off the phone.

    댓글 쓰기

    • The back of the phone will look like this when the battery is correctly removed.

    댓글 쓰기

    • Peel the rubber indicated toward the top of the phone

    댓글 쓰기

  3. Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
    Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
    • Remove the screw that sits underneath the rubber covering.

    댓글 쓰기

    • Remove the five (5) total screws using a Philips head screwdriver.

    댓글 쓰기

    • Use spudger and insert it towards the bottom of the phone as pictured.

    • Carefully working yourself around the phone with the spudger, pry it open. This may require a bit of force.

    • The volume control button will be loose, so make sure to take it out once the rear case is fully removed.

    댓글 쓰기

    • The back case should now be completely removed and the motherboard will be visible.

    댓글 쓰기

    • Disconnect the gold connection patch

    • Use a spudger or finger to disconnect the piece.

    댓글 쓰기

    • Using a spudger, lift the motherboard out of the phone case as pictured.

    댓글 쓰기

    • The motherboard should now be completely removed from the phone.

    댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

Sean Green

회원 가입일: 2010년 10월 04일

11 평판

안내서 2개 작성하였습니다

Cal Poly, Team 3-24, Regan Fall 2010 Cal Poly, Team 3-24, Regan Fall 2010 회원

CPSU-REGAN-F10S3G24

4 회원들

안내서 12개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 2

전체 시간: 2,068