기기를 수리하세요 커뮤니티 상점

Autosampler Battery Replacement & Voltage Check (For Old & New Versions)

필요한 것

  1. Autosampler Battery Replacement & Voltage Check (For Old & New Versions), Disconnect the batteries completely: 1 단계, 이미지 1/3 Autosampler Battery Replacement & Voltage Check (For Old & New Versions), Disconnect the batteries completely: 1 단계, 이미지 2/3 Autosampler Battery Replacement & Voltage Check (For Old & New Versions), Disconnect the batteries completely: 1 단계, 이미지 3/3

    • 1. Disconnect the plug to the solar panel (yellow circle).

    • Then, grabbing the green connector and pull the battery connector from the solar charge controller (blue arrow).

    • This will be done inside the node. It was removed from the node to make it easier to see for the tutorial.

    • 2. Disconnect the plugs for the autosampler battery.

    • 3. Disconnect the connector that plugs into the battery port of the sampler.

    • If disconnect battery before solar panel, this can damage the solar charger!

    편집

  3. Autosampler Battery Replacement & Voltage Check (For Old & New Versions), Checking battery voltages: 2 단계, 이미지 1/3 Autosampler Battery Replacement & Voltage Check (For Old & New Versions), Checking battery voltages: 2 단계, 이미지 2/3 Autosampler Battery Replacement & Voltage Check (For Old & New Versions), Checking battery voltages: 2 단계, 이미지 3/3

    • 4. Make sure multimeter is measuring in DC current (red boxes).

    • Make sure multimeter is measuring in Volts (blue box).

    • 5. Check the voltage of the lead acid autosampler battery. Fully charged lead acid battery should be around 13-14 V.

    • Remember: Red to red and black to black!

    • 6. Check the voltage of the lithium ion node battery. Fully charged lithium ion battery should around 4 V.

    편집

  4. Autosampler Battery Replacement & Voltage Check (For Old & New Versions), Reconnect the batteries: 3 단계, 이미지 1/3 Autosampler Battery Replacement & Voltage Check (For Old & New Versions), Reconnect the batteries: 3 단계, 이미지 2/3 Autosampler Battery Replacement & Voltage Check (For Old & New Versions), Reconnect the batteries: 3 단계, 이미지 3/3

    • 7. First reconnect the autosampler battery (black box).

    • 8. Then reconnect lithium ion battery in the node (blue box).

    • Remember to plug in the other connector into the autosampler.

    • 9. Secure solar charge controller to the side of the enclosure using velcro (red box).

    • Then plug in the solar panel last (orange box).

    편집
결승점

다른 3명이 해당 안내서를 완성하였습니다.

작성자

다른 기여자 1명과 함께

Brooke Mason

회원 가입일: 05/29/19

2,928 평판

안내서 17개 작성하였습니다

배지: 21

배지 +18개 더

팀

Open-Storm Open-Storm 회원

Community

14 회원들

안내서 24개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 150