기기를 수리하세요 커뮤니티 상점

Autosampler Configuration for Node Control (For Old & New Versions)

필요한 것

  1. Autosampler Configuration for Node Control (For Old & New Versions), Starting the configuration process.: 1 단계, 이미지 1/3 Autosampler Configuration for Node Control (For Old & New Versions), Starting the configuration process.: 1 단계, 이미지 2/3 Autosampler Configuration for Node Control (For Old & New Versions), Starting the configuration process.: 1 단계, 이미지 3/3

    • 1. Turn on the autosampler. Screen will read "...STANDBY..."

    • 2. Press "ENTER/PROGRAM" button. Use arrows to highlight "CONFIGURE". Press "ENTER/PROGRAM" button

    • This will allow you to use the arrows to shuffle through the different configuration options. To select the one you want, press the "ENTER/PROGRAM" button.

    • 3. Use arrows to find "EVENT MARK". Press the "ENTER/PROGRAM" button.

    편집

  3. Autosampler Configuration for Node Control (For Old & New Versions), Configuring "event mark".: 2 단계, 이미지 1/3 Autosampler Configuration for Node Control (For Old & New Versions), Configuring "event mark".: 2 단계, 이미지 2/3 Autosampler Configuration for Node Control (For Old & New Versions), Configuring "event mark".: 2 단계, 이미지 3/3

    • 4. Use arrow to select "CONTINUOUS SIGNAL". Press "ENTER/PROGRAM" button.

    • 5. Use arrow to select "PUMP CYCLE". Press "ENTER/PROGRAM" button.

    • It is critical this setting is configured in order for the sensor node to operate the autosampler!

    • 6. Use arrows to find "EXIT CONFIGURATION." Press "ENTER/PROGRAM" button. This will bring up the screen "...STANDBY...

    편집
결승점

다른 한 분이 해당 안내서를 완성하였습니다.

작성자

다른 기여자 1명과 함께

Brooke Mason

회원 가입일: 05/29/19

2,928 평판

안내서 17개 작성하였습니다

배지: 21

배지 +18개 더

팀

Open-Storm Open-Storm 회원

Community

14 회원들

안내서 24개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 87