BLACK and DECKER BDERO100 Hook and Loop System Replacement - iFixit 수리 안내서

소개

This guide provides information on how to remove and replace the hook and loop system of the BLACK and DECKER BDERO100 5 inch sander. The only tool that you will need for this process is the JIS - J1 bit or equivalent.

필요한 것

1 단계 Hook and Loop System

BLACK and DECKER BDERO100 Hook and Loop System Replacement, Hook and Loop System: 1 단계, 이미지 1/1

Remove the sanding paper from the velcro.

2 단계

BLACK and DECKER BDERO100 Hook and Loop System Replacement: 2 단계, 이미지 1/1

Select the JIS - J1 bit or the most appropriate bit to match the screws for your model.

3 단계

BLACK and DECKER BDERO100 Hook and Loop System Replacement: 3 단계, 이미지 1/2

BLACK and DECKER BDERO100 Hook and Loop System Replacement: 3 단계, 이미지 2/2

Use the Bit Driver to take off the four 12.5 mm Phillips screws at the base of the hook-and-loop system.
Be careful not to lose the lock washers (black rings).

4 단계

BLACK and DECKER BDERO100 Hook and Loop System Replacement: 4 단계, 이미지 1/2

BLACK and DECKER BDERO100 Hook and Loop System Replacement: 4 단계, 이미지 2/2

Once all screws and washers have been removed, hold the hook and loop system and separate it from the device.

결론

To reassemble your device, follow these instructions in reverse order.

작성자

다른 기여자 2명과 함께

Christian Moss

회원 가입일: 02/10/16

101 평판

안내서 1개 작성함

팀

USF Tampa, Team 1-5, Sullivan Spring 2016 USF Tampa, Team 1-5, Sullivan Spring 2016 회원

USFT-SULLIVAN-S16S1G5

4 회원들

안내서 6개 작성하였습니다

댓글 0개

조회 통계:

24 시간 전: 0

7일 전: 2

30일 전: 9

전체 시간: 1,530