주요 콘텐츠로 건너뛰기

기기를 수리하세요

수리할 권리

상점

소개

Use this guide to replace the right trigger on your Backbone One.

  1. Use a Phillips screwdriver to remove the four 5.9 mm-long screws.
    • Use a Phillips screwdriver to remove the four 5.9 mm-long screws.

  2. Lift up the upper cover of the controller. Swing the upper cover over and place it on the controller case. Make sure that the interconnecting cable has no tension.
    • Lift up the upper cover of the controller.

    • Swing the upper cover over and place it on the controller case.

    • Make sure that the interconnecting cable has no tension.

  3. Use a pair of tweezers to remove the yellow protective tape which is placed over the interconnect cable and the connector. Use a pair of tweezers to remove the yellow protective tape which is placed over the interconnect cable and the connector. Use a pair of tweezers to remove the yellow protective tape which is placed over the interconnect cable and the connector.
    • Use a pair of tweezers to remove the yellow protective tape which is placed over the interconnect cable and the connector.

  4. Use the tip of an opening pick to open the gray flap of the interconnect cable ZIF connector by pushing it upwards. Use the tip of an opening pick to open the gray flap of the interconnect cable ZIF connector by pushing it upwards. Use the tip of an opening pick to open the gray flap of the interconnect cable ZIF connector by pushing it upwards.
    • Use the tip of an opening pick to open the gray flap of the interconnect cable ZIF connector by pushing it upwards.

  5. Disconnect the cable by pulling it straight out the ZIF connector. Disconnect the cable by pulling it straight out the ZIF connector.
    • Disconnect the cable by pulling it straight out the ZIF connector.

  6. Use a pair of tweezers to disconnect the phone connector cables out from their sockets. Use a pair of tweezers to disconnect the phone connector cables out from their sockets. Use a pair of tweezers to disconnect the phone connector cables out from their sockets.
    • Use a pair of tweezers to disconnect the phone connector cables out from their sockets.

  7. Separate the the upper case of the left controller handle.
    • Separate the the upper case of the left controller handle.

  8. Use a Phillips screwdriver to remove the three 5.9 mm-long screws.
    • Use a Phillips screwdriver to remove the three 5.9 mm-long screws.

  9. Remove the trigger. Remove the trigger.
    • Remove the trigger.

결론

To reassemble your device, follow these instructions in reverse order.

Opening didn’t go as planned? Answers community for help.

Adriana Zwink

회원 가입일: 2019년 12월 18일

12,020 평판

안내서 68개 작성하였습니다

iFixit iFixit 회원

Community

134 회원들

안내서 14,946개 작성하였습니다

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 1

30일 전: 2

전체 시간: 2