소개

Upon completion of this guide, you can successfully install and replace the motor fan for you blender.

Before disassembling the blender base, make sure the blender disconnected from any power outlet.
  • Before disassembling the blender base, make sure the blender disconnected from any power outlet.

  • Lift the jar straight up from the base without tilting the jar.

댓글 쓰기

Remove the top three 1/4 inch base screws using a Philip's head screwdriver.
  • Remove the top three 1/4 inch base screws using a Philip's head screwdriver.

댓글 쓰기

  • Remove the two base leg covers next to the power cord using pliers or a flat-head screwdriver.

  • This provides access to the base screws beneath.

댓글 쓰기

  • Remove the following screws that secure the top and bottom halves of the base.

    • One 1/4 Phillips screw

    • One TA-20 screw

  • Both screwdrivers must have a minimum of a three inch shank (length).

  • Screwdrivers with extenders will not fit down the access holes.

댓글 쓰기

  • Lift the top half of the base from the bottom half of the base to reveal the internal mechanism.

댓글 쓰기

  • Using pliers, remove the top nut from the fan and remove the washer.

  • Use a small towel to hold the fan in place. This makes taking off the nut easier to do.

댓글 쓰기

  • Lift the fan blades from the blender base.

댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

다른 2명이 해당 안내서를 완성하였습니다.

Andrew

회원 가입일: 2012년 10월 04일

170 평판

안내서 4개 작성하였습니다

Cal Poly, Team 6-34, Regan Fall 2012 Cal Poly, Team 6-34, Regan Fall 2012 회원

CPSU-REGAN-F12S6G34

4 회원들

안내서 6개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 4

지난 30일: 23

전체 시간: 2,577