Black and Decker IR02V-T Power Cord Replacement

소개

This guide demonstrates how to replace a Black & Decker IR02V-T flat iron power cord. A guide like this is crucial because any internal damage to your power cord could lead to a short circuit and would ruin the flat iron.

When completing the process ensure the flatiron is unplugged and has completely cooled down.

필요한 것

1 단계 Power Cord

Black and Decker IR02V-T Power Cord Replacement, Power Cord: 1 단계, 이미지 1/3

Black and Decker IR02V-T Power Cord Replacement, Power Cord: 1 단계, 이미지 2/3

Black and Decker IR02V-T Power Cord Replacement, Power Cord: 1 단계, 이미지 3/3

Remove the two silicone covers which encase the screws.
Remove both 1 mm screws using a T5 Torx screwdriver.
Pry open the plastic cover starting from the top of the iron.

편집

2 단계

Black and Decker IR02V-T Power Cord Replacement: 2 단계, 이미지 3/3

Remove both caps from the end of the wire by using pliers.
Unfold the metal in the caps using the pliers to release the exposed wire.
Remove the two 1 mm screws holding down the wire using a Phillips #00 screwdriver.
Once the wires are exposed separate and fold to opposite sides.

편집

3 단계

Black and Decker IR02V-T Power Cord Replacement: 3 단계, 이미지 3/3

Remove the old power cord from the iron completely.
Insert the new cord through the plastic cover and hole of the iron as demonstrated in the image.

편집

4 단계

Black and Decker IR02V-T Power Cord Replacement: 4 단계, 이미지 3/3

Expose about half an inch of wire by removing the silicone that encases it.
Tie the new wire into a knot and connect the wires accordingly.
Place the caps over the exposed wire and use pliers to tighten the metal to secure the wire.

편집

5 단계

Black and Decker IR02V-T Power Cord Replacement: 5 단계, 이미지 3/3

Once the caps are over the wires add the two 1 mm Phillips screws along with the small base plate which secures the wire.
When all wires are secure place the plastic cover and screw back in the 1mm Torx screws.

편집