Black and Decker WP900 Power Cord Replacement - iFixit 수리 안내서

소개

This page gives instructions for disassembling the Black and Decker WP900 6-Inch Orbital Waxer and Polisher to the point where the power cable can be fully removed and replaced.

필요한 것

1 단계 Power Cord

Black and Decker WP900 Power Cord Replacement, Power Cord: 1 단계, 이미지 1/1

Using the plastic tool, detach the handle tab as shown.
Make sure the device is unplugged.

2 단계

Black and Decker WP900 Power Cord Replacement: 2 단계, 이미지 1/1

Using the Philips #1 screwdriver, unscrew all of the screws. There should be 8-30mm screws to remove.
Be sure to keep track of where each screw was placed in the device for later reassembly.

3 단계

Black and Decker WP900 Power Cord Replacement: 3 단계, 이미지 1/3

Black and Decker WP900 Power Cord Replacement: 3 단계, 이미지 2/3

Black and Decker WP900 Power Cord Replacement: 3 단계, 이미지 3/3

Remove the back panel of the external casing, leaving all internal components resting in the front panel.
Remove the black handle from the main external casing.

4 단계

Black and Decker WP900 Power Cord Replacement: 4 단계, 이미지 1/1

Loosen the power cord and control panel. Using the Phillips #1 screwdriver, remove two 22mm screws.
The metal bracket will detach with the two screws.
Using the Flathead 3/32" screwdriver, remove two 22mm screws.

5 단계

Black and Decker WP900 Power Cord Replacement: 5 단계, 이미지 1/2

Black and Decker WP900 Power Cord Replacement: 5 단계, 이미지 2/2

Gently pull the power cord out from the control module.
This is the part to be replaced. Remember to insert the black wire into the top port when installing the new cord.

결론

To reassemble your device, follow these instructions in reverse order.

작성자

다른 기여자 1명과 함께

Cameron

회원 가입일: 02/15/16

231 평판

안내서 2개 작성하였습니다

배지 +9개 더

팀

IUPUI, Team 8-8, Wilson Spring 2016 IUPUI, Team 8-8, Wilson Spring 2016 회원

IUPUI-WILSON-S16S8G8

4 회원들

안내서 4개 작성하였습니다

댓글 0개

조회 통계:

24 시간 전: 0

7일 전: 4

30일 전: 13

전체 시간: 281