소개

This is a guide on how to replace the logic board on your Blackberry 7510.

부품

부품은 필요하지 않습니다.

  1. Remove the battery cover and battery before continuing.
    • Remove the battery cover and battery before continuing.

    • Remove the six T6 Torx screws on the back of the phone.

    • Make sure to keep the screws somewhere that they will not get lost.

    댓글 쓰기

  2. Using your finger nail or a spudger, carefully pry up the back cover.
    • Using your finger nail or a spudger, carefully pry up the back cover.

    • Begin in one spot and slowly circle around the device as you pry up all of the back cover.

    댓글 쓰기

    • Lift off the back cover.

    댓글 쓰기

    • Remove the two T6 screws.

    댓글 쓰기

    • Remove the daughterboard.

    • Remove the exposed vibration motor.

    댓글 쓰기

    • Using the T6 Torx screwdriver, remove the top screw.

    댓글 쓰기

    • Using your spudger, carefully pry off back plate.

    • Use the same technique as with the plastic back cover. Circle around the back plate until all of it is pried up.

    댓글 쓰기

    • Remove the front cover and keypad.

    댓글 쓰기

    • Remove one T6 Torx screw in the front bottom right of the board.

    댓글 쓰기

    • Carefully pry the screen from the board with your spudger.

    • After prying it up, remove the screen from the board.

    댓글 쓰기

    • Unscrew center T6 Torx screw in the center of the logic board.

    • Remove the logic board from the phone.

    • Replace with new logic board.

    댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

Neil Johnson

회원 가입일: 2010년 01월 24일

12 평판

안내서 6개 작성하였습니다

Cal Poly, Team 14-44, Regan Winter 2010 Cal Poly, Team 14-44, Regan Winter 2010 회원

CPSU-REGAN-W10S14G44

4 회원들

안내서 8개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 1

전체 시간: 1,784