Skip to main content

소개

Replace your cracked LCD screen with a new one.

부품

No parts specified.

  1. Remove the battery cover by applying pressure and sliding down the silver square on the back of the phone.
    • Remove the battery cover by applying pressure and sliding down the silver square on the back of the phone.

  2. Remove the battery by prying under it with your finger or the plastic opening tool. Remove the four small 3/8" long screws using a 1/16" diameter torx screwdriver.
    • Remove the battery by prying under it with your finger or the plastic opening tool.

    • Remove the four small 3/8" long screws using a 1/16" diameter torx screwdriver.

  3. Use a nylon spudger to carefully remove the two side bars of plastic. Use a nylon spudger to carefully remove the two side bars of plastic.
    • Use a nylon spudger to carefully remove the two side bars of plastic.

  4. 아이폰 배터리 수리 키트

    Only $29.99

    Buy Now

    아이폰 배터리 수리 키트

    Only $29.99

    Buy Now
  5. Use a nylon spudger to carefully pry the back casing off.
    • Use a nylon spudger to carefully pry the back casing off.

    • There are two small clamps on each edge that need to be unhooked before the casing will come off.

  6. Pry off the front casing.
    • Pry off the front casing.

    • Be aware of sensors and other sensitive areas of the newly exposed electronics.

  7. After disassembling the outer casing, the phone should be stripped as shown.
    • After disassembling the outer casing, the phone should be stripped as shown.

  8. At the top of the phone, locate the gloss SATA cable strap connecting the LCD screen to the phone. Using the prying tool, unattach this cable by levering under the connector.
    • At the top of the phone, locate the gloss SATA cable strap connecting the LCD screen to the phone.

    • Using the prying tool, unattach this cable by levering under the connector.

  9. Using the prying tool, lever up the old screen as shown. WARNING: Be sure to have disconnected the SATA cable strap prior to attempting this.
    • Using the prying tool, lever up the old screen as shown.

    • WARNING: Be sure to have disconnected the SATA cable strap prior to attempting this.

  10. Insert new LCD screen. Attach cable to the connector located at the top of the phone.
    • Insert new LCD screen.

    • Attach cable to the connector located at the top of the phone.

    • Phone should look as it was prior to screen removal.

결론

To reassemble your device, follow these instructions in reverse order.

ryan

회원 가입일: 2013년 04월 12일

41 평판

안내서 5개 작성하였습니다

Cal Poly, Team 13-64, Johann Spring 2013 Cal Poly, Team 13-64, Johann Spring 2013 회원

CPSU-JOHANN-S13S13G64

4 회원들

안내서 7개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 0

전체 시간: 478