소개

The purpose is to remove both the main circuit board and the roller ball unit from the main frame of the phone.

부품

부품은 필요하지 않습니다.

There are four screws total on the back of the phone casing near edge of battery area.
  • There are four screws total on the back of the phone casing near edge of battery area.

  • The two closer to the top of the phone are protected by plastic stoppers. Remove them then remove the screws.

  • There are two more screws on either side of where the battery was located. remove them as well.

댓글 쓰기

Remove the bottom plastic piece.
  • Remove the bottom plastic piece.

  • This may require prying from a few different directions. The plastic blue prying tool featured here may be required.

댓글 쓰기

  • Once the keypad is removed, the buttons on the sides of the phone will fall out.

  • You will need to loosen the board from the right side opposite the charging ports.

  • Pull gently towards the right side so the ports clear the plastic casing.

  • Gently flip the board over to the left.

댓글 쓰기

  • On the back of the circuit board you will find a small rectangular blue piece with a black 'L' shape in the middle.

  • Gently detach this from the back of the main board.

  • Now you may fully remove the main board.

댓글 쓰기

  • What is left inside the phone is the roller ball.

  • Gently use the plastic blue tool to detach it from the frame.

댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

Ashley

회원 가입일: 2013년 04월 15일

306 평판

안내서 3개 작성하였습니다

SUNY Cortland, Team 1-5, Getto Spring 2013 SUNY Cortland, Team 1-5, Getto Spring 2013 회원

SUNYCORT-GETTO-S13S1G5

3 회원들

안내서 3개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 1

지난 30일: 2

전체 시간: 514