기기를 수리하세요 커뮤니티 상점

Blackberry Torch 9800 Logic Board Replacement

소개

This guide takes you through the steps to remove a logic board in a Blackberry Torch 9800. Installing the new logic board is the same process, in reverse. This project will void your phone warranty.

필요한 것

  1. Blackberry Torch 9800 Logic Board Replacement, Logic Board Replacement: 1 단계, 이미지 1/2 Blackberry Torch 9800 Logic Board Replacement, Logic Board Replacement: 1 단계, 이미지 2/2

    • Remove the back cover and the battery.

    • Unscrew the four screws using a T6 screwdriver.

    • Removing the top right screw (with the blue cover) will void the warranty.

    번역하기

  2. Blackberry Torch 9800 Logic Board Replacement: 2 단계, 이미지 1/2 Blackberry Torch 9800 Logic Board Replacement: 2 단계, 이미지 2/2

    • Remove the side trim using the plastic opening tool.

    • Apply pressure to push the top side of the side trim towards the phone while pulling the bottom away from the phone to remove the side trim.

    • The side trim is fragile and easily fractured, so handful it with care.

    번역하기

  4. Blackberry Torch 9800 Logic Board Replacement: 3 단계, 이미지 1/3 Blackberry Torch 9800 Logic Board Replacement: 3 단계, 이미지 2/3 Blackberry Torch 9800 Logic Board Replacement: 3 단계, 이미지 3/3

    • Remove the two screws that have been revealed at the top of the device using the T6 screwdriver.

    • You should now be able to easily lift the back panel from the phone.

    번역하기

  5. Blackberry Torch 9800 Logic Board Replacement: 4 단계, 이미지 1/2 Blackberry Torch 9800 Logic Board Replacement: 4 단계, 이미지 2/2

    • Using your hands, carefully peel the three ribbon cable caps from the logic board.

    번역하기

  6. Blackberry Torch 9800 Logic Board Replacement: 5 단계, 이미지 1/2 Blackberry Torch 9800 Logic Board Replacement: 5 단계, 이미지 2/2

    • Lift logic board slightly. The logic board will remain attached to the phone by a small antenna wire.

    • Using your hands, carefully lift the clasp attached to the antenna wire straight upward away from the logic board.

    • Make sure not to disconnect the antenna wire from its clasp.

    • The logic board should now be completely separate from the phone.

    번역하기
결론

To reassemble your device, follow these instructions in reverse order.

다른 3명이 해당 안내서를 완성하였습니다.

작성자

다른 기여자 5명과 함께

Keegan Williams

회원 가입일: 02/19/16

216 평판

안내서 2개 작성하였습니다

배지: 6

배지 +3개 더

팀

Ohio State, Team 1-5, Garvin Spring 2016 Ohio State, Team 1-5, Garvin Spring 2016 회원

OSU-GARVIN-S16S1G5

3 회원들

안내서 3개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 2

7일 전: 11

30일 전: 24

전체 시간: 856