주요 콘텐츠로 건너뛰기

Boosted Board 1st Generation Rear Wheels Replacement

필요한 것

  1. Boosted Board 1st Generation Rear Wheels Replacement, Rear Wheels: 1 단계, 이미지 1/2 Boosted Board 1st Generation Rear Wheels Replacement, Rear Wheels: 1 단계, 이미지 2/2
    • Loosen the two 16.74 mm motor mount hex nut screws with a 9/64" Allen wrench.

    • Do Not Remove the Screws.

  2. Boosted Board 1st Generation Rear Wheels Replacement: 2 단계, 이미지 1/1
    • Compress the motor mount back towards the wheel.

    • While keeping the motor mount compressed, tighten one of the hex nuts that you loosened in the previous step.

    • The motor mounts are spring tensioned so it is necessary compress them to loosen the belts.

  3. Boosted Board 1st Generation Rear Wheels Replacement: 3 단계, 이미지 1/2 Boosted Board 1st Generation Rear Wheels Replacement: 3 단계, 이미지 2/2
    • Remove the axel nut with a 1/2" socket wrench

  4. Boosted Board 1st Generation Rear Wheels Replacement: 4 단계, 이미지 1/3 Boosted Board 1st Generation Rear Wheels Replacement: 4 단계, 이미지 2/3 Boosted Board 1st Generation Rear Wheels Replacement: 4 단계, 이미지 3/3
    • Rotate and pull counterclockwise until the wheel comes off the axle completely.

    • The front washer will come off with the wheel.

    • Remove the back washer from the axle.

    • Replacing the wheel requires the bearings to be switched into the new wheel.

결론

To reassemble your device, follow these instructions in reverse order.

Emily Imfeld

회원 가입일: 10/06/16

532 평판

안내서 4개 작성하였습니다

Cal Poly, Team 15-7, Livingston Fall 2016 Cal Poly, Team 15-7, Livingston Fall 2016 회원

CPSU-LIVINGSTON-F16S15G7

4 회원들

안내서 6개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 4

전체 시간: 1,255