주요 콘텐츠로 건너뛰기

소개

Good bearings are essential for smooth ride. This guide will help you take out and replace the skateboard bearings on the rear or front wheels of your Boosted Board. You can choose to replace the bearings with new ones, or just clean the existing bearings.

도구

부품

지정된 부품이 없습니다.

  1. Loosen the two 16.74 mm motor mount hex nut screws with a 9/64" Allen wrench. Do Not Remove the Screws.
    • Loosen the two 16.74 mm motor mount hex nut screws with a 9/64" Allen wrench.

    • Do Not Remove the Screws.

  2. Compress the motor mount back towards the wheel.
    • Compress the motor mount back towards the wheel.

    • While keeping the motor mount compressed, tighten one of the hex nuts that you loosened in the previous step.

    • The motor mounts are spring tensioned so it is necessary compress them to loosen the belts.

  3. Remove the axel nut with a 1/2" socket wrench Remove the axel nut with a 1/2" socket wrench
    • Remove the axel nut with a 1/2" socket wrench

  4. Rotate and pull counterclockwise until the wheel comes off the axle completely. The front washer will come off with the wheel. Remove the back washer from the axle.
    • Rotate and pull counterclockwise until the wheel comes off the axle completely.

    • The front washer will come off with the wheel.

    • Remove the back washer from the axle.

    • Replacing the wheel requires the bearings to be switched into the new wheel.

  5. Use one finger to pull out the pulley bearing. A good technique is to go around in a circle and lift from underneath the bearing in a carving motion.
    • Use one finger to pull out the pulley bearing.

    • A good technique is to go around in a circle and lift from underneath the bearing in a carving motion.

  6. Use an Allen wrench to apply pressure to the inside edge of the bearing until it pops out Use an Allen wrench to apply pressure to the inside edge of the bearing until it pops out Use an Allen wrench to apply pressure to the inside edge of the bearing until it pops out
    • Use an Allen wrench to apply pressure to the inside edge of the bearing until it pops out

  7. Replace bearing by dropping it in the center of the wheel and use a socket wrench to pop in back it place Replace bearing by dropping it in the center of the wheel and use a socket wrench to pop in back it place Replace bearing by dropping it in the center of the wheel and use a socket wrench to pop in back it place
    • Replace bearing by dropping it in the center of the wheel and use a socket wrench to pop in back it place

  8. Slide the bearing spacer on to an Allen wrench Align the Allen wrench in the center of the bearing and drop the spacer directly in the middle Repeat Step 7 for placing the bearing in this side of the wheel.
    • Slide the bearing spacer on to an Allen wrench

    • Align the Allen wrench in the center of the bearing and drop the spacer directly in the middle

    • Repeat Step 7 for placing the bearing in this side of the wheel.

결론

To reassemble your device, follow these directions in reverse order.

Emily Imfeld

회원 가입일: 2016년 10월 06일

514 평판

안내서 4개 작성하였습니다

Cal Poly, Team 15-7, Livingston Fall 2016 Cal Poly, Team 15-7, Livingston Fall 2016 회원

CPSU-LIVINGSTON-F16S15G7

4 회원들

안내서 6개 작성하였습니다

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 7

전체 시간: 492