메인 콘텐츠로 스킵하기

소개

This guide can be used to remove and replace the Circuit Board for the Bose Cinemate 10. There are no prerequisite replacement guides to replace the Circuit Board. It should take approximately 10 mins to complete this replacement guide.

부품

지정된 부품이 없습니다.

  1. Locate the cable input port, on the back of the device. Remove the 2, PH1, 15mm screws.
    • Locate the cable input port, on the back of the device.

    • Remove the 2, PH1, 15mm screws.

  2. Gently, pull the base of the A/V cable directly outward, away from the main body of the device. Slide the plastic cover to the right, which should free the cover from the main body of the device. Slide the plastic cover to the right, which should free the cover from the main body of the device.
    • Gently, pull the base of the A/V cable directly outward, away from the main body of the device.

    • Slide the plastic cover to the right, which should free the cover from the main body of the device.

  3. 맥북 배터리 수리 키트

    기본 가격은 $69.99

    Buy Now

    맥북 배터리 수리 키트

    기본 가격은 $69.99

    Buy Now
  4. Using your fingers, gently pull outward on the multi-colored wire bundle until the black plastic wire harness is visible. Press on the latch on the black plastic wire harness, and pull the multi-colored wire bundle simultaneously. The cables should now be detached from the harness. Press on the latch on the black plastic wire harness, and pull the multi-colored wire bundle simultaneously. The cables should now be detached from the harness.
    • Using your fingers, gently pull outward on the multi-colored wire bundle until the black plastic wire harness is visible.

    • Press on the latch on the black plastic wire harness, and pull the multi-colored wire bundle simultaneously. The cables should now be detached from the harness.

  5. Using your fingers, grasp the edges of cable input port. Gently pull the cable input port away from main body of device. The Circuit Board should now be completely separated from the main body of the device. Gently pull the cable input port away from main body of device. The Circuit Board should now be completely separated from the main body of the device.
    • Using your fingers, grasp the edges of cable input port.

    • Gently pull the cable input port away from main body of device. The Circuit Board should now be completely separated from the main body of the device.

  6. Press the tab on side of white plastic cable harness, and pull gently on the  multi-colored wire bundle simultaneously. The cable should completely detach from the Circuit Board. Press the tab on side of white plastic cable harness, and pull gently on the  multi-colored wire bundle simultaneously. The cable should completely detach from the Circuit Board. Press the tab on side of white plastic cable harness, and pull gently on the  multi-colored wire bundle simultaneously. The cable should completely detach from the Circuit Board.
    • Press the tab on side of white plastic cable harness, and pull gently on the multi-colored wire bundle simultaneously. The cable should completely detach from the Circuit Board.

결론

To reassemble your device, follow these instructions in reverse order.

다른 2명이 해당 안내서를 완성하였습니다.

Phillip Halverson

회원 가입일: 2018년 09월 26일

335 평판

안내서 2개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 4

지난 30일: 22

전체 시간: 153