주요 콘텐츠로 건너뛰기

Bose SoundDock Portable v2 Speaker Replacement

필요한 것

  1. Bose SoundDock Portable v2 Speaker Replacement, Speaker: 1 단계, 이미지 1/3 Bose SoundDock Portable v2 Speaker Replacement, Speaker: 1 단계, 이미지 2/3 Bose SoundDock Portable v2 Speaker Replacement, Speaker: 1 단계, 이미지 3/3
    • Gently pry the front mesh cover off of the SoundDock using a metal spudger.

    • The mesh is held on by small velcro strips so if you hear a tearing sound it is just the velcro coming apart

  2. Bose SoundDock Portable v2 Speaker Replacement: 2 단계, 이미지 1/2 Bose SoundDock Portable v2 Speaker Replacement: 2 단계, 이미지 2/2
    • Remove the four 16mm #2 screws holding the speaker to the base using a #2 screwdriver

    • Gently lift the speaker from the base.

    • Do not lift the speaker to far out of the base, you may damage the wires.

  3. Bose SoundDock Portable v2 Speaker Replacement: 3 단계, 이미지 1/1
    • You will notice 2 coils of wire around the speaker's input tabs. Slide these coils off as un-winding the wires may break the wires. Slide the coils around your new driver.

결론

To reassemble your device, follow these instructions in reverse order.

다른 4명이 해당 안내서를 완성하였습니다.

Evan Low

회원 가입일: 04/14/15

551 평판

안내서 4개 작성하였습니다

Cal Poly, Team 4-1, Maness Spring 2015 Cal Poly, Team 4-1, Maness Spring 2015 회원

CPSU-MANESS-S15S4G1

4 회원들

안내서 5개 작성하였습니다

댓글 5개

I am unsure of what to do in step #3…

Is the purpose to remove the speaker completely and place a brand new one? (Making sure not to pull the old speaker too far out as to not break any wire… ) ???

Edited comment:

I am not sure what they mean by "pins".

vero198099 - 답글

Hi I just accidently pushed in that dome part in the middle a little and now it distorts. I tried using a vacuum but it didnt work. Please help!!!!!!!!

AJ Grape - 답글

Try to see if there’s any way you can reduce the nozzle size of the vacuum cleaner you’re using - this should increase the flow rate, and possibly the amount of force applied over such a small area.

Alternatively, you can use a very very fine needle, bend the end of it, and use it to “hook” the cone. This method is really a last resort, as you want to avoid making even the smallest of holes.

Absolute last resort is replacing the speaker, which if you can find a replacement, should be pretty easy.

Colm Donnelly -

Need help love this speaker when it’s played loud it makes a load noise when the base is on changed aux lead think it’s the speaker what do I do

Chantelle Webb - 답글

How do you cut on without remote

Chad Davenport - 답글

댓글 쓰기

조회 통계:

24 시간 전: 2

7일 전: 9

30일 전: 55

전체 시간: 11,677