주요 콘텐츠로 건너뛰기

기기를 고치세요

수리할 권리

부품 & 도구

소개

If you are going to replace any of the major components of your camera, you will need to first remove the back panel. This guide will teach you how to open up your camera.

부품

지정된 부품이 없습니다.

  1. Lay the camera on its back so that the card/battery door is facing you.
    • Lay the camera on its back so that the card/battery door is facing you.

    • Using your fingernail, slide the tab on the battery door up to release the battery door latch.

  2. Lift the now free card/battery door to reveal the battery compartment.
    • Lift the now free card/battery door to reveal the battery compartment.

    • Push the gray lever to the right side so that the battery can be removed and replaced with a new one.

  3. Turn the camera so that the back is facing to your right.
    • Turn the camera so that the back is facing to your right.

    • Remove the 5mm Phillips #000 screw above the rubber USB port cover.

  4. Essential Electronics Toolkit

    Small Toolkit. Big Possibilities.

    Shop Toolkits

    Essential
    Electronics
    Toolkit

    Shop Toolkits
  5. Remove the rubber piece.
    • Remove the rubber piece.

    • Unscrew the two screws under the rubber cover to completely remove the rubber cover piece.

    • It is held in place by a notched tether, but can be easily manipulated to slide out.

  6. Turn your camera so that the bottom is facing you.
    • Turn your camera so that the bottom is facing you.

    • Remove the 5mm Phillips #000 screws.

  7. Now turn the camera so that the front is facing towards your right.
    • Now turn the camera so that the front is facing towards your right.

    • Remove the two remaining 5mm Phillips #000 screws.

  8. Now that all of the exterior screws have been removed, grip the camera firmly on both sides. Gently pry the back panel from the main body of the camera. There are two ribbon cables that need to be removed in order for the back panel to come free from the camera body, as indicated.
    • Now that all of the exterior screws have been removed, grip the camera firmly on both sides.

    • Gently pry the back panel from the main body of the camera.

    • There are two ribbon cables that need to be removed in order for the back panel to come free from the camera body, as indicated.

    • This back panel contains various control components of the camera as well as the LCD screen.

결론

To reassemble your device, follow these instructions in reverse order.

다른 4명이 해당 안내서를 완성하였습니다.

Johnyp

회원 가입일: 2015년 08월 26일

244 평판

안내서 1개 작성함

USF Tampa, Team 16-4, Wollert Fall 2015 USF Tampa, Team 16-4, Wollert Fall 2015 회원

USFT-WOLLERT-F15S16G4

4 회원들

안내서 14개 작성하였습니다

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 3

30일 전: 40

전체 시간: 2,067