소개

Use this guide to replace the grip of the camera.

부품

부품은 필요하지 않습니다.

Remove the two 3mm (1/8") black screws from the side cover using a #00 Phillips screwdriver.
  • Remove the two 3mm (1/8") black screws from the side cover using a #00 Phillips screwdriver.

댓글 쓰기

On the bottom, remove the 6mm (13/64") screw with the #00 Phillips Screwdriver.
  • On the bottom, remove the 6mm (13/64") screw with the #00 Phillips Screwdriver.

  • Pry up the panel; starting from the front/bottom corner, as indicated.

    • There's a concealed lip, under the opposite edge.

댓글 쓰기

  • Remove three medium length screws from the bottom of the camera

댓글 쓰기

  • Remove the two medium length screws on the front panel of the camera above the lens mount.

  • Once you done, you may use the Spudger to panel from non-grip side.

  • If you start on the grip side, it will be more challenging to loosen the panel.

댓글 쓰기

  • Remove the two 4.5mm (.18in) long black screws from the camera grip using a #00 Phillips screwdriver.

댓글 쓰기

  • Use your fingertip to pry off the external shutter port cover.

댓글 쓰기

  • Remove the two 5mm (.20in) long silver screws securing the grip to the camera using a #00 Phillips screwdriver.

댓글 쓰기

  • Use the spudger tool to carefully pry the grip from the rest of the camera.

댓글 쓰기

  • Once the grip is loose, use your fingers to remove it from the camera.

댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

Daniel Bussone

회원 가입일: 2011년 01월 28일

1,215 평판

안내서 11개 작성하였습니다

Cal Poly, Team 3-41, Regan Winter 2011 Cal Poly, Team 3-41, Regan Winter 2011 회원

CPSU-REGAN-W11S3G41

2 회원들

안내서 11개 작성하였습니다

Little confused. Some pics are from a analog Canon, other from a digital Canon...

Gustavo Aguiar - 답글

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 3

지난 30일: 18

전체 시간: 2,950