소개

The Cannon PowerShot A1000 IS is a compact digital camera. This guide gives instructions to remove and reattach the plastic casing when attempting internal repairs.

Transfer screws to a safe place upon removal.
  • Transfer screws to a safe place upon removal.

  • The case is held together with two types of screws: fine thread screws that attach the case to the metal parts below, and coarse thread screws that attach the case to the plastic battery compartment.

댓글 쓰기

Remove the two coarse thread screws on the side of the device, to the left of the camera lens.
  • Remove the two coarse thread screws on the side of the device, to the left of the camera lens.

댓글 쓰기

  • Remove the two fine thread screws on the side of the device, to the right of the camera lens.

댓글 쓰기

  • Remove the two coarse thread screws and the single fine thread screw from bottom the camera.

댓글 쓰기

  • Remove the one coarse thread screw underneath the battery cover.

댓글 쓰기

  • Gently pry apart the two covers starting from the bottom. When there is a 1/4" gap, run your finger gently along the the top of the camera, on the back cover, to release the three catches that secure the shell.

댓글 쓰기

  • Gently remove both sides of the casing.

댓글 쓰기

  • When replacing the cover, remove the AV/USB rubber cover for easier reconstruction.

  • Replace the front cover first leaving a small gap on the left hand side of the device for easy reattachment of the back cover.

  • Reattach the back cover by aligning it with the front cover and snapping the latches into place. Secure with screws in any order.

댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

다른 2명이 해당 안내서를 완성하였습니다.

Biff Wheeler

회원 가입일: 2012년 06월 06일

738 평판

안내서 4개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 2

지난 30일: 11

전체 시간: 1,513