주요 콘텐츠로 건너뛰기

부품

지정된 부품이 없습니다.

  1. Open the battery door by sliding the tab on the battery door while pushing the battery door away from the camera. Remove batteries.
    • Open the battery door by sliding the tab on the battery door while pushing the battery door away from the camera.

    • Remove batteries.

  2. Remove the three indicated .2mm screws using a Phillips #00 screwdriver. Gently pull off side-panel to remove it.
    • Remove the three indicated .2mm screws using a Phillips #00 screwdriver.

    • Gently pull off side-panel to remove it.

  3. Remove the two indicated .2mm screws using a Phillips #00 screwdriver.
    • Remove the two indicated .2mm screws using a Phillips #00 screwdriver.

  4. Remove the indicated .2mm screw using a Phillips #00 screwdriver. Remove the three .2mm screws located on the internal side of the top panel within the battery chamber using a Phillips #00 screwdriver.
    • Remove the indicated .2mm screw using a Phillips #00 screwdriver.

    • Remove the three .2mm screws located on the internal side of the top panel within the battery chamber using a Phillips #00 screwdriver.

  5. Open 'DIGITAL A/V OUT' door on camera. Remove the two indicated .2mm screws using a Phillips #00 screwdriver.
    • Open 'DIGITAL A/V OUT' door on camera.

    • Remove the two indicated .2mm screws using a Phillips #00 screwdriver.

  6. Grip the sides of the top panel and gently pull to separate the top panel from the camera body.
    • Grip the sides of the top panel and gently pull to separate the top panel from the camera body.

    • The top panel will not completely detach.

  7. Gently pull the front and back panels apart, and use a Phillips #00 screwdriver to remove the screw connecting the panels. Gripping the top and bottom, gently pull the front panel away from the camera body to remove it.
    • Gently pull the front and back panels apart, and use a Phillips #00 screwdriver to remove the screw connecting the panels.

    • Gripping the top and bottom, gently pull the front panel away from the camera body to remove it.

  8. Use the spudger to gently pull back the retaining clip and pull the ribbon out
    • Use the spudger to gently pull back the retaining clip and pull the ribbon out

    • The top panel should now be completely detached from the camera

    • Applying to much force to the spudger may damage the retaining clip

  9. Remove the two screws holding down the metal frame using the Phillips #00 screwdriver
    • Remove the two screws holding down the metal frame using the Phillips #00 screwdriver

  10. Lift up the metal frame to expose the two screws located under the trigger button.
    • Lift up the metal frame to expose the two screws located under the trigger button.

    • Remove the two screws using Phillips #00 screwdriver

  11. Trigger button should fall out Trigger button should fall out
    • Trigger button should fall out

결론

To reassemble your device, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

Kelly Duggan

회원 가입일: 2014년 10월 13일

439 평판

안내서 3개 작성하였습니다

Clemson, Team 2-5, Benson Fall 2014 Clemson, Team 2-5, Benson Fall 2014 회원

CLEM-BENSON-F14S2G5

4 회원들

안내서 9개 작성하였습니다

댓글 쓰기

조회 통계:

24 시간 전: 1

7일 전: 4

30일 전: 6

전체 시간: 277