메인 콘텐츠로 스킵하기

소개

In this guide, we will be showing you how to remove the flash dial in order to replace it.

부품

지정된 부품이 없습니다.

  1. Remove the five 2mm  Phillips #000 screws that are under the screen of the camera.
    • Remove the five 2mm Phillips #000 screws that are under the screen of the camera.

  2. Remove the two 3mm Phillips #000 screws under the AV-out digital flap.
    • Remove the two 3mm Phillips #000 screws under the AV-out digital flap.

    • Remove the two 3 mm Phillips #000 screws from the side of the camera.

  3. Remove the two 3 mm Phillips #000 screws on the side of camera with the flash toggle.
    • Remove the two 3 mm Phillips #000 screws on the side of camera with the flash toggle.

  4. 맥북 배터리 수리 키트

    기본 가격은 $69.99

    Buy Now

    맥북 배터리 수리 키트

    기본 가격은 $69.99

    Buy Now
  5. Remove the four 4 mm Phillips #000 screws from the plate on the bottom of the camera.
    • Remove the four 4 mm Phillips #000 screws from the plate on the bottom of the camera.

  6. Remove the back plate.
    • Remove the back plate.

  7. Remove the three 3 mm Phillips #000 screws around the dial.
    • Remove the three 3 mm Phillips #000 screws around the dial.

  8. Using  the nylon spudger, gently lift the ZIF tab. Disconnect the ribbon cable that connects the dial to the motherboard.
    • Using the nylon spudger, gently lift the ZIF tab.

    • Disconnect the ribbon cable that connects the dial to the motherboard.

    • Remove the dial from the device.

결론

To reassemble your device, follow these instructions in reverse order.

McKenzie Devlin

회원 가입일: 2018년 04월 09일

195 평판

안내서 1개 작성함

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 3

전체 시간: 182