주요 콘텐츠로 건너뛰기

Canon PowerShot S500 LCD Replacement

필요한 것

  1. Canon PowerShot S500 LCD Replacement, Front and Rear Casing : 1 단계, 이미지 1/2 Canon PowerShot S500 LCD Replacement, Front and Rear Casing : 1 단계, 이미지 2/2
    • Unscrew five Phillips screws using a #0 Phillips screwdriver.

    • One screw is on upper right corner of the back panel.

    • The other four screws are on the bottom of the camera.

  2. Canon PowerShot S500 LCD Replacement: 2 단계, 이미지 1/1
    • Open the memory card cover by moving the slide switch toward the top end of of the camera.

    • Remove the memory card from the slot.

  3. Canon PowerShot S500 LCD Replacement: 3 단계, 이미지 1/1
    • Remove the rear cover from the rest of the camera.

    • This may require gentle rocking of the case to free it.

  4. Canon PowerShot S500 LCD Replacement: 4 단계, 이미지 1/2 Canon PowerShot S500 LCD Replacement: 4 단계, 이미지 2/2
    • Unscrew the four Phillips screws from the side of the casing and one screw from the bottom using a #0 Phillips screwdriver.

  5. Canon PowerShot S500 LCD Replacement: 5 단계, 이미지 1/1
    • Free the front cover from the rest of the camera.

    • The cover may require gentle rocking to remove.

  6. Canon PowerShot S500 LCD Replacement, LCD: 6 단계, 이미지 1/1
    • Unscrew two Phillips screws above the LCD using a #0 Phillips screwdriver.

  7. Canon PowerShot S500 LCD Replacement: 7 단계, 이미지 1/1
    • Gently separate the top of LCD from the rest of the camera using your thumb.

    • Be careful not pull the LCD too far because of the ribbon cable connection.

    • Place the Spudger in the hole of the electrical ribbon.

    • Gently pull the ribbon down using the Spudger until it is free from the camera but still connected to the LCD.

    • The LCD will still be connected to the rest of the camera

  8. Canon PowerShot S500 LCD Replacement: 8 단계, 이미지 1/2 Canon PowerShot S500 LCD Replacement: 8 단계, 이미지 2/2
    • Unscrew single Phillips screw with a #0 Phillips screwdriver.

    • Free the bottom panel and attached ribbon from the rest of the camera.

    • Be careful not to damage the ribbon.

  9. Canon PowerShot S500 LCD Replacement: 9 단계, 이미지 1/1
    • Turn over the camera.

    • Lift the clear plastic from the face of the camera, peeling the adhesive just below the zoom lens.

    • The plastic will still be connected on the left side.

  10. Canon PowerShot S500 LCD Replacement: 10 단계, 이미지 1/1
    • Place the Spudger between the orange ribbon and the black ribbon gate.

    • Lift the ribbon gate using the Spudger.

  11. Canon PowerShot S500 LCD Replacement: 11 단계, 이미지 1/1
    • Place the Spudger in the corner of the ribbon above the hole.

    • Remove the ribbon from the ribbon gate by pulling the Spudger away from the gate.

  12. Canon PowerShot S500 LCD Replacement: 12 단계, 이미지 1/1
    • Free this ribbon and the bottom panel from the rest of the camera.

    • Be careful not to damage the ribbon.

  13. Canon PowerShot S500 LCD Replacement: 13 단계, 이미지 1/1
    • Turn the camera over so you can see the LCD.

    • Remove single Phillips screw below the LCD using a #0 Phillips screwdriver.

  14. Canon PowerShot S500 LCD Replacement: 14 단계, 이미지 1/1
    • Lift the blue ribbon gate using the Spudger.

  15. Canon PowerShot S500 LCD Replacement: 15 단계, 이미지 1/1
    • Insert the Spudger into the hole of the ribbon.

    • Move the Spudger away from the gate to fully remove ribbon.

    • Be careful not to damage the ribbon.

  16. Canon PowerShot S500 LCD Replacement: 16 단계, 이미지 1/1
    • Lift the LCD away from the rest of the camera.

결론

To reassemble your device, follow these instructions in reverse order.

Nathan Balcom

회원 가입일: 01/21/10

81 평판

안내서 8개 작성하였습니다

Cal Poly, Team 16-28, Maness Winter 2010 Cal Poly, Team 16-28, Maness Winter 2010 회원

CPSU-MANESS-W10S16G28

4 회원들

안내서 8개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 1

30일 전: 11

전체 시간: 3,100