소개

This guide is a walk-through of the process to replace a dead, dying, or incorrectly placed battery and an SD card in a Canon PowerShot SD 600.

  1. Turn the camera over so that the battery compartment is visible. The compartment should read "Card/Batt. Open".
    • Turn the camera over so that the battery compartment is visible. The compartment should read "Card/Batt. Open".

    • Open the compartment.

      • Lightly push the compartment lid down and outward. The arrow next to "Card/Batt. Open" indicates the direction you should be pushing.

    댓글 쓰기

  2. Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
    Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
  3. Once the lid is open, the battery and SD card compartments become visible.
    • Once the lid is open, the battery and SD card compartments become visible.

    • Notice the red tab on the right side of the battery.

      • Slide this tab off the battery.

      • The battery is now free to slide out of the compartment.

      • The battery will not pop out of the compartment. The camera needs to be tilted in order to slide the battery out.

    댓글 쓰기

    • To remove the SD card push it down and it will eject out. (SD card not shown)

    • Be sure the new or recharged battery is facing the correct direction. An arrow on the battery indicates which end should be inserted into the compartment first.

    • If you plan on dissembling the camera further, you should leave the battery and SD card removed. Make sure to close the battery compartment once the battery and the SD card are removed.

    댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

Krystal Eades

회원 가입일: 2013년 03월 11일

1 평판

안내서 4개 작성하였습니다

Clemson, Team 13-5, Benson Spring 2013 Clemson, Team 13-5, Benson Spring 2013 회원

CLEM-BENSON-S13S13G5

3 회원들

안내서 11개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 1

전체 시간: 223