주요 콘텐츠로 건너뛰기

Canon PowerShot SD700 Backlight Replacement

필요한 것

  1. Canon PowerShot SD700 Backlight Replacement, Outside Case: 1 단계, 이미지 1/1
    • Turn off the camera by pressing the power button above the LCD screen.

  2. Canon PowerShot SD700 Backlight Replacement: 2 단계, 이미지 1/1
    • Remove the two, small screws on the bottom of the camera using a Phillip's #00 screwdriver.

  3. Canon PowerShot SD700 Backlight Replacement: 3 단계, 이미지 1/1
    • Use a Phillips #00 screwdriver to remove the two, small screws on the right side of the camera.

  4. Canon PowerShot SD700 Backlight Replacement: 4 단계, 이미지 1/1
    • Use a Phillips #00 screwdriver to remove the screw on the left of the camera under the A/V out Digital label.

  5. Canon PowerShot SD700 Backlight Replacement: 5 단계, 이미지 1/1
    • Use a Phillips #00 screwdriver, remove the screw on the bottom of the camera near the battery and memory card slots.

    • This screw will be longer than the rest of the screws.

  6. Canon PowerShot SD700 Backlight Replacement: 6 단계, 이미지 1/1
    • Remove the front, back, and side casings from the camera and set to the side.

  7. Canon PowerShot SD700 Backlight Replacement, LCD screen: 7 단계, 이미지 1/1
    • Remove the two screws that connect the LCD and backlight to the main body of the camera.

  8. Canon PowerShot SD700 Backlight Replacement: 8 단계, 이미지 1/3 Canon PowerShot SD700 Backlight Replacement: 8 단계, 이미지 2/3 Canon PowerShot SD700 Backlight Replacement: 8 단계, 이미지 3/3
    • Gently pry the LCD and the backlight from the main body of the camera.

    • Gently pry the LCD from the backlight.

    • The thin ribbon cable is for the backlight.

    • The thick ribbon cable is for the LCD screen.

  9. Canon PowerShot SD700 Backlight Replacement: 9 단계, 이미지 1/1
    • Carefully lift the ZIF connector that covers the thick ribbon cable.

    • This ZIF connector is fragile. Use caution when lifting it from its down position.

    • Insert the new LCD and reassemble the camera.

  10. Canon PowerShot SD700 Backlight Replacement, Backlight: 10 단계, 이미지 1/1
    • Unplug the ribbon from the housing on the circuitry.

    • Take the new ribbon and insert it into the housing.

    • Tweezers or a tool with a sharp point can be used.

결론

To reassemble your device, follow these instructions in reverse order.

Emilio Rossi

회원 가입일: 04/07/11

113 평판

안내서 3개 작성하였습니다

Cal Poly, Team 9-71, Walters Spring 2011 Cal Poly, Team 9-71, Walters Spring 2011 회원

CPSU-WALTERS-S11S9G71

4 회원들

안내서 9개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 4

전체 시간: 1,606