주요 콘텐츠로 건너뛰기

소개

This guide explains the location of exterior screws and the process to remove the rear panel of the Canon Powershot A70 camera.

  1. Unscrew the three small screws on the bottom of the camera with a Phillips #00 screwdriver.
    • Unscrew the three small screws on the bottom of the camera with a Phillips #00 screwdriver.

    • Remove the wrist strap.

  2. Remove the screw in the CF compartment with a Phillips #00 screwdriver.
    • Remove the screw in the CF compartment with a Phillips #00 screwdriver.

  3. Open the rubber Digital AV Out compartment flap. Pry the battery with an opening tool. Carefully pull out the battery with two fingers.
    • Open the rubber Digital AV Out compartment flap.

    • Pry the battery with an opening tool.

    • Carefully pull out the battery with two fingers.

    • Remove the two screws that are now visible with a Phillips #00 screwdriver.

  4. Starting from the bottom, carefully pull the casing off. The casing will now pivot at the top.
    • Starting from the bottom, carefully pull the casing off.

    • The casing will now pivot at the top.

    • There are three catches that hold the back casing to the body.

    • You may have to pull with some force. The rear panel will make a snapping noise when it separates from the body.

  5. The interior of the camera should look like this.
    • The interior of the camera should look like this.

결론

To reassemble your device, follow these instructions in reverse order.

Shalan Ertis

회원 가입일: 2010년 01월 26일

68 평판

안내서 3개 작성하였습니다

Cal Poly, Team 14-40, Regan Winter 2010 Cal Poly, Team 14-40, Regan Winter 2010 회원

CPSU-REGAN-W10S14G40

5 회원들

안내서 15개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 2

30일 전: 2

전체 시간: 3,092