주요 콘텐츠로 건너뛰기

소개

Quick guide on removing and replacing the plastic back cover. Replacement is required if the functions buttons fail to work, or the casing has been damaged.

  1. Position the camera so that the right side is visible as shown. Unscrew the two 6 mm screws shown using a screwdriver.
    • Position the camera so that the right side is visible as shown.

    • Unscrew the two 6 mm screws shown using a screwdriver.

  2. Remove the plastic flap by pressing down on the center of the hinge and pulling on the flap with the spudger. Then, unscrew the lone 6mm screw that was under the plastic flap. Then, unscrew the lone 6mm screw that was under the plastic flap.
    • Remove the plastic flap by pressing down on the center of the hinge and pulling on the flap with the spudger.

    • Then, unscrew the lone 6mm screw that was under the plastic flap.

  3. Turn the camera so that the bottom is visible, as shown. Unscrew the three 4mm screws shown red using a screwdriver.
    • Turn the camera so that the bottom is visible, as shown.

    • Unscrew the three 4mm screws shown red using a screwdriver.

    • Unscrew the single 6mm screw.

    • Do not touch the screw shown yellow, removal is unnecessary. (Note: the top right yellow screw should be removed)

  4. Turn the camera so the back side is visible, as shown.
    • Turn the camera so the back side is visible, as shown.

    • Unscrew the two 6mm screws.

  5. Gently remove the back cover using the spudger.
    • Gently remove the back cover using the spudger.

    • Exercise caution, as the wire inside is fragile.

  6. Detach the wire by lifting the small black bar that holds it to the main body of the camera. Detach the wire by lifting the small black bar that holds it to the main body of the camera.
    • Detach the wire by lifting the small black bar that holds it to the main body of the camera.

  7. Attach the new cover onto the camera.
    • Attach the new cover onto the camera.

  8. Reattach the wire to your new rear casing.
    • Reattach the wire to your new rear casing.

  9. Close the back cover, and re-insert appropriate screws.
    • Close the back cover, and re-insert appropriate screws.

결론

To reassemble your device, follow these instructions in reverse order.

다른 2명이 해당 안내서를 완성하였습니다.

Ellis DeVoe

회원 가입일: 2015년 04월 14일

574 평판

안내서 5개 작성하였습니다

Cal Poly, Team 5-12, Maness Spring 2015 Cal Poly, Team 5-12, Maness Spring 2015 회원

CPSU-MANESS-S15S5G12

4 회원들

안내서 5개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 3

30일 전: 4

전체 시간: 1,049