-
Remove wrist strap and battery.
-
Remove 2 screws from each side of the camera (4 total, 0.102 in).
-
Remove 2 screws from the bottom on the camera (0.138 in).
-
Gently pull off the front cover.
-
Gently pull off the back cover.
-
The cases should now be removed.
This can be a bit tricky when reassembling. All of the little tabs around the edge need to snap into their proper places, and there are three cover pieces to manage. Plus, you need to make sure that the camera/video/playback switch is properly engaged with its slider on the circuit board, otherwise you'll need to raise the back panel and reposition everything again.
oh yes , i agree lol
elbala80 -
-
Clean around the function buttons with a cotton swab dipped in isopropyl alcohol.
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
다른 한 분이 해당 안내서를 완성하였습니다.
팀
Cal Poly, Team 3-32, Regan Winter 2011 Cal Poly, Team 3-32, Regan Winter 2011 회원
CPSU-REGAN-W11S3G32
3 회원들
안내서 8개 작성하였습니다
