1. Turn the device upside down. Remove all four rubber feet by prying them out using the metal spudger. Once the rubber feet have been removed, use the Phillips #2 screwdriver to remove all four 13mm screws.
    • Turn the device upside down.

    • Remove all four rubber feet by prying them out using the metal spudger.

    • Once the rubber feet have been removed, use the Phillips #2 screwdriver to remove all four 13mm screws.

  2. Remove the base from the body of the blender. Remove the base from the body of the blender.
    • Remove the base from the body of the blender.

  3. Remove the two 11mm screws securing the power cord using the Phillips #2 screwdriver. Gently move the wire aside so that it is not in the way. Gently move the wire aside so that it is not in the way.
    • Remove the two 11mm screws securing the power cord using the Phillips #2 screwdriver.

    • Gently move the wire aside so that it is not in the way.

  4. US$100 이상 또는 Pro Tech Toolkit을 포함한 모든 주문의 배송은 무료입니다!

    상점 둘러보기
  5. Remove the four 13mm screws that hold the black plastic cover using the Phillips #2 screwdriver. Gently remove the black cover. Underneath you will see a clear plastic cover that should be removed as well. Gently remove the black cover. Underneath you will see a clear plastic cover that should be removed as well.
    • Remove the four 13mm screws that hold the black plastic cover using the Phillips #2 screwdriver.

    • Gently remove the black cover. Underneath you will see a clear plastic cover that should be removed as well.

  6. Cut the zip tie that holds the black, blue, red, and yellow wires together. Take care not to cut the wires.
    • Cut the zip tie that holds the black, blue, red, and yellow wires together.

    • Take care not to cut the wires.

  7. Remove the 2 black, yellow, and red wires from circuit board by push down on the tab to release and then pull up. Remove the 2 black, yellow, and red wires from circuit board by push down on the tab to release and then pull up.
    • Remove the 2 black, yellow, and red wires from circuit board by push down on the tab to release and then pull up.

  8. Pinch perpendicular to the flat surface and pull out the black wire.
    • Pinch perpendicular to the flat surface and pull out the black wire.

결론

To reassemble your device, follow these instructions in reverse order.

Mary Harold

회원 가입일: 2018년 09월 24일

88 평판

안내서 1개 작성함

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 0

전체 시간: 52