주요 콘텐츠로 건너뛰기

소개

This guide will outline the steps required to replace the landing gear on the DJI Phantom 3 Advanced. This includes unscrewing the landing gear as well as removing the receiver antenna from the gear in order to replace the gear.

부품

지정된 부품이 없습니다.

  1. With the battery facing you, locate the two tabs on the top and bottom of the battery as shown. Remember to disarm and power down your quadcopter before beginning any disassembly.
    • With the battery facing you, locate the two tabs on the top and bottom of the battery as shown.

    • Remember to disarm and power down your quadcopter before beginning any disassembly.

  2. Press the two tabs with your finger and thumb, and gently slide the battery towards you, out of the quadcopter frame. With your other hand, be sure to hold the quadcopter steady to ensure that it stays still.
    • Press the two tabs with your finger and thumb, and gently slide the battery towards you, out of the quadcopter frame.

    • With your other hand, be sure to hold the quadcopter steady to ensure that it stays still.

  3. Turn the phantom upside down. Remove the eight 7.5mm long 3mm screws, securing the landing gear to the body of the quadcopter, with a T-8 screwdriver. Remove the eight 7.5mm long 3mm screws, securing the landing gear to the body of the quadcopter, with a T-8 screwdriver.
    • Turn the phantom upside down.

    • Remove the eight 7.5mm long 3mm screws, securing the landing gear to the body of the quadcopter, with a T-8 screwdriver.

  4. Remove the rubber spacer in the landing gear by pushing the spacer out of the slot with your finger. Remove the rubber spacer in the landing gear by pushing the spacer out of the slot with your finger. Remove the rubber spacer in the landing gear by pushing the spacer out of the slot with your finger.
    • Remove the rubber spacer in the landing gear by pushing the spacer out of the slot with your finger.

  5. Using a plastic opening tool, carefully separate the two pieces of plastic of the landing gear. Be careful not to break the wire attached, as this is your receiver antenna. Be careful not to break the wire attached, as this is your receiver antenna.
    • Using a plastic opening tool, carefully separate the two pieces of plastic of the landing gear.

    • Be careful not to break the wire attached, as this is your receiver antenna.

  6. Feed the wire and attached plastic through the hole in the landing gear. Feed the wire and attached plastic through the hole in the landing gear. Feed the wire and attached plastic through the hole in the landing gear.
    • Feed the wire and attached plastic through the hole in the landing gear.

결론

To reassemble your device, follow these instructions in reverse order.

다른 5명이 해당 안내서를 완성하였습니다.

Quinn Tirpak

회원 가입일: 2016년 10월 06일

271 평판

안내서 2개 작성하였습니다

Cal Poly, Team 10-2, Livingston Fall 2016 Cal Poly, Team 10-2, Livingston Fall 2016 회원

CPSU-LIVINGSTON-F16S10G2

3 회원들

안내서 12개 작성하였습니다

댓글 한 개

I have a single coax cable in my landing gear. the gear broke and the wire tore off the connector. How do I fix this?

Art - 답글

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 2

30일 전: 12

전체 시간: 3,187