기기를 수리하세요 커뮤니티 상점

DJI Spark Lid Replacement

소개

Follow this guide to remove the lid on your DJI Spark. The lid needs to be removed to get access to the internals. The propellers and battery need to be taken out first before proceeding with detaching the lid. It is an easy 5-step process that can be done in less than 30 seconds.

필요한 것

  1. DJI Spark Lid Replacement, Propellers: 1 단계, 이미지 1/1

    • Push down on the propeller that is being replaced.

    편집

  2. DJI Spark Lid Replacement: 2 단계, 이미지 1/2 DJI Spark Lid Replacement: 2 단계, 이미지 2/2

    • Twist the propeller until it feels loose.

    • Pull on it until it comes off.

    편집

  4. DJI Spark Lid Replacement, Battery: 3 단계, 이미지 1/3 DJI Spark Lid Replacement, Battery: 3 단계, 이미지 2/3 DJI Spark Lid Replacement, Battery: 3 단계, 이미지 3/3

    • Flip the drone over.

    • Grip the left and right sides of the battery.

    • Slide firmly forward until it pops out.

    편집

  5. DJI Spark Lid Replacement, Lid: 4 단계, 이미지 1/3 DJI Spark Lid Replacement, Lid: 4 단계, 이미지 2/3 DJI Spark Lid Replacement, Lid: 4 단계, 이미지 3/3

    • Flip the drone over.

    • Remove the four 1.5mm Hex screws.

    • Remove the two 1.5mm Hex screws near the camera head.

    • You may need to remove plastic nubs from the hex screws using a spudger first.

    편집

  6. DJI Spark Lid Replacement: 5 단계, 이미지 1/3 DJI Spark Lid Replacement: 5 단계, 이미지 2/3 DJI Spark Lid Replacement: 5 단계, 이미지 3/3

    • Hold the drone so the lid is facing up.

    • Insert the plastic opening tool into the side of the drone.

    • Slide the tool around the perimeter until you can lift the top off.

    편집
결론

To reassemble your device, follow these instructions in reverse order.

작성자

다른 기여자 7명과 함께

Uzochi Anyanwu

회원 가입일: 10/21/19

408 평판

안내서 4개 작성하였습니다

배지: 8

배지 +5개 더

팀

UMass Dartmouth, Team S1-G7, Botvin Fall 2019 UMass Dartmouth, Team S1-G7, Botvin Fall 2019 회원

UMASSD-BOTVIN-F19S1G7

3 회원들

안내서 7개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 1

30일 전: 4

전체 시간: 962